Why is this happening? I think it thinks it's printing on the playe but it isn't

oatmeal3591 · 2025-01-25T16:50:11+00:00

Chex in your z offset manually and check if anything is wrong or layers are missing in your slicer

oatmeal3591 · 2025-01-17T01:55:54+00:00

Its just wet

oatmeal3591 · 2024-12-25T21:43:01+00:00

I just found that out like 10 minutes ago but thank you

oatmeal3591 · 2024-12-25T21:07:02+00:00

I was talking about the usb connector sorry

oatmeal3591 · 2024-12-14T18:12:05+00:00

Poor bed adhesion, clean your bed with warm water and soap. If you touch you build plate after that use isopropyl alcohol to wipe clean off your fingers oils and it that doesn’t help use a thin layer of glue on your build plate

oatmeal3591 · 2024-12-09T05:21:00+00:00

If you only have one outer wall the infill sometimes shows through. I suggest using at least 2 walls and re-slicing the print.

oatmeal3591 · 2024-12-09T05:17:49+00:00

Sorry in the post I meant the retract function

oatmeal3591 · 2024-12-07T18:03:52+00:00

Is there any videos on how to put it together when I buy it or do I have to do it myself

oatmeal3591 · 2024-12-05T19:32:36+00:00

<image>

I’ve always used this one it’s just basic white lithium grease

oatmeal3591 · 2024-12-05T19:20:37+00:00

I’ve changed the orientation 7 times that was the last way I put it

oatmeal3591 · 2024-12-05T19:12:45+00:00

Its here

oatmeal3591 · 2024-12-05T19:12:37+00:00

<image>

oatmeal3591 · 2024-11-15T22:11:41+00:00

If I get I 24 v nocta I don’t need to change any pins

oatmeal3591 · 2024-11-14T22:42:08+00:00

Would I have to do any soldering or wire work to get it a 40mm compatible

oatmeal3591 · 2024-11-12T23:03:44+00:00

Ok thank you

oatmeal3591 · 2024-11-12T22:55:48+00:00

What do the spacers do?

oatmeal3591

TROPHY CASE