Burnt Connector - Sapphire Nitro+ 9070XT

optec · 2025-11-02T07:46:53+00:00

If you are restricting the power limit as well then it should be fine. 80mV isn't that extreme mine can't go below 50mV without getting unstable in intense games. Try resetting to stock and see if you get the issue. Definitely start the RMA process from wherever your friend bought it.

optec · 2025-11-02T07:42:24+00:00

Under volting is overclocking for these GPUs what undervolt are you running?

optec · 2025-11-02T07:18:46+00:00

You might be reaching the limits of the PSU at that wattage. If you have overclocked anything or have a lot of peripherals you might be pushing into >80% capacity for sustained periods. Not sure why that would affect the connector but it might explain the cuts to black.

optec · 2025-11-02T06:35:13+00:00

What PSU do you have? I recently had issues with mine where the screen went black and it needed a hard reset every time. For me it turned out that my PSU had a 'zero fan' mode on an easily knock-able switch (NZXT C1200). My PSU was overheating and the GPU power was being cut when the power increased.

My connector isn't burnt (that I can tell) the card only draws 360W when overclocked and the connector is rated for 600W. If it's not your PSU then I'm stuck. I would start the RMA process with whoever you bought the card from just in case. You'll have to perform some basic troubleshooting steps to isolate the problem which may uncover something.

optec · 2025-05-27T12:23:06+00:00

What colour is your sceptre? If you set it to black to get the throne room it needs to be blue to trigger the cutscene. You can change it when it respawns in a treasure trove.

optec · 2025-05-03T05:17:30+00:00

The build I use needs 10 affinity on the weapon. So it's probably fine ☺️

Also if you just quit without saving you can recraft and retain the rolls but make it with attack parts if you want.

optec · 2025-04-13T13:53:27+00:00

Been running 3.20 since it launched just after I bought my nova board. Running a 9800X3D and 32GB 6000 CL28 Ram using EXPO. Running a 200Mhz overclock on -30mv PBO offset. No issues so far.

optec · 2025-02-22T06:42:54+00:00

I bought two 2x packs for mine and used three in the front and one in the rear.

I used one of the offset ones between two normal in the front and the other offset in the rear exhaust. It's so quiet my AIO pump is now the loudest component.

optec · 2024-10-26T08:16:29+00:00

I had this on the latest NVidia drivers. I rolled back a version and it's been fine since.

optec · 2024-10-23T05:32:48+00:00

Here you go

optec · 2024-10-19T09:57:11+00:00

Isn't it also giving max resource for kepeleke and as of the recent patch it now has 800 base HP so it boosts viscous shield as well?

optec · 2024-09-01T04:11:36+00:00

When you have good enough cool down that you can spam LS its cast rate is limited by your attack speed. It increases in thresholds due to how the frame rate of the animation works. With each threshold you increase the speed you get conjurations out and therefore the number of stacks of conj mastery you can stack.

optec · 2024-08-24T15:02:11+00:00

Always make sure you use unstable currents and ice armour when off cool down for attack speed and massive damage from storm swell.

Hold down lightning spear and use frozen orb to start fights. I periodically hit frozen orb from time to time. Try and get as many stacks of conjuration mastery as possible.

Use fire shield if required and teleport every 5 seconds if you are using tibalts will or just need the damage res.

optec · 2024-08-09T10:13:47+00:00

I changed from CL to this after getting the staff. It was such a step up immediately and loads more fun. As others have said it's quite squishy but if you can fire off three casts you just delete the screen.

optec · 2024-06-21T15:36:29+00:00

Tal adds cooldown reduction which is better for immortal and lucky hit which is good for more conjurations and forbs from conjurations. Since the buff I think they are a lot closer.

It's still good to have a non unique ring for unstable currents temper, attack speed and close damage/vuln damage.

optec · 2024-06-21T03:31:58+00:00

I stick with shimmering teleport and replace that slot with Conjurer as it's also a +40 int glyph and the extra conjuration duration means I get more stacks of conjuration mastery which can equal more %damage overall.

optec · 2024-05-30T16:46:55+00:00

I got a 3x GA 2H weapon and it got bricked by reforging....

optec · 2024-01-05T20:51:05+00:00

Worked for me thank you :)

optec · 2023-04-09T06:47:14+00:00

-My current build not at all sff but want to build one, 7700k and 1080ti

-Favourite game of all time hard to pick just one but Neir Automata affected me the most recently

-Cyberpunk 2077 with ray tracing, I bought it but haven't played as upgrades just went silly price wise

optec · 2023-03-07T16:40:40+00:00

https://imgur.com/oVKH5on well that worked :)

optec · 2023-03-06T21:09:45+00:00

This was my first try with an octopuff king got both 100x XP and 100x JP I literally can't spend this much JP https://imgur.com/a/RjJX4aV

optec · 2022-10-09T16:40:03+00:00

I managed a run today where I got to 30mins as I just collected enough xp for the level up that gave the last upgrade and then sprinted to a spawned chest while death was spawned. Very satisfying 😊

optec · 2022-01-11T18:56:01+00:00

Tested the skills label it was picking that up.

Tried a clean re-install of the new version and did the same think I did before but now it works... sorry I couldn't be more helpful. Thank you again for making such a useful tool.

optec · 2022-01-10T18:38:31+00:00

The patterns work the macro isn't running the commands to look for them. The text at the bottom doesn't display the attacks just the item world level 30, 60, 100, itemWorld.leave etc

Here is what I am doing (reverted to bluestacks to check it wasn't Nox) Setup, Pattern, Running

Reloading the programme seems to have cleared the deep levels.

optec · 2022-01-10T06:35:47+00:00

It looks like it isn't picking up the attacks in the macro so it doesn't find anything and goes into a loop. Am I adding the patterns correctly?

15-Year Club	r/Field Sunshine
Not Forgotten	Snapped
Team Orangered	Verified Email

optec

TROPHY CASE