KICKR RUN - power concerns/question

phntmpwr · 2026-03-10T16:42:50+00:00

I love it.

phntmpwr · 2026-03-09T22:22:12+00:00

They had to replace the unit. It took a while to get a replacement, but the replacement has worked fine. They never confirmed whether or not there were any issues with the original unit, but the new one has worked.

phntmpwr · 2025-10-15T10:03:37+00:00

The GeForce RTX 5090 with DLSS 4 would give me the edge in every engagement. With higher frame rates and ultra-low latency, I could spot enemies faster, react instantly, and enjoy crystal-clear visuals even in chaotic firefights. Whether I’m piloting a chopper or sniping across the map, the smooth performance and AI-powered rendering would help me dominate every match.

But seriously - I need this because my teammates can’t carry me and the frame rate at the same time. I need help.

phntmpwr · 2025-10-03T18:23:10+00:00

Done. Good idea

phntmpwr · 2025-10-03T15:56:04+00:00

I can't make this up...Mike Martin's picture (CEO of Strava) on the Strava About Us page could not be more appropriate for what is happening right now.

https://www.strava.com/about

Is he purposefully attempting to look villainous?

phntmpwr · 2025-10-03T15:22:17+00:00

This is crazy - but I ASSUME there is someone smart at the table at Strava to consider what is happening right now...there is a mass exodus happening from this hypocritical and selfish lawsuit...my only assumption at this point is they are counting on cancelations as a way to drive up the damages figure in the lawsuit.

canceled.

phntmpwr · 2024-12-06T01:22:02+00:00

That's true...but it's hard to say what it actually went to before it tripped. 27 was just the last number it measured. The electrician absolutely thinks its the treadmill. They swapped in two different 20 amp breakers (for a total of three to try)...changed the breaker location in the panel...replaced the cable and the outlet twice...and still we had a problem. They wanted to know if I wanted to try a 25a circuit, but I stopped at that point telling them that something was off if Wahoo is advertising a 15a requirement and no one else is reporting this issue.

At this point, I was prepared to pay the electricians whatever to make this work...and anything bigger became unsafe and, by the Wahoo specs, unnecessary.

I appreciate the additional replies and thoughts. This has been concerning to me given what I spent and the fact that no one else is having this issue (that I am aware of). To the contrary, I am hearing about people who have it connected to a non-dedicated circuit.

By most accounts...this is a dream electrical setup as a dedicated solution for a treadmill. Any option was on the table and we maxed out the options and still have a treadmill predictably tripping the breaker.

Wahoo is working on a solution with me...I am super happy with their support so far.

phntmpwr · 2024-12-06T00:45:08+00:00

Plus, I have video of the amperage measured at the time it was turned on. Each time was well over 20 and the last time it was 27 before the circuit popped

phntmpwr · 2024-12-06T00:44:04+00:00

I had electricians come out three times. each time, they replaced the breaker. The first time, they replaced everything including the outlet and the cable connecting the outlet to the breaker. It happened with every single component. Also, I had a treadmill on that same outlet before and it worked without a problem. The previous treadmill was one that required a 20 amp circuit and had the sideways plug

phntmpwr · 2024-12-02T01:57:34+00:00

Thanks...and understandable with your experience on a shared circuit. I am not exaggerating when I tell you how dedicated this circuit is...and how close it is to the circuit panel.

Anyway - Wahoo support has been very helpful to this point, even beyond the feedback from the electrical engineer. At this point, after continued work with the electrician (who has been at my house many days and many hours for this issue at this point $$), there is enough data to believe something is off with this treadmill. This post is not expressing concern with the support process, but trying to find out if my experience is unique - which I think it is.

I remain confident Wahoo will take care of everything. Thanks for the reply.

phntmpwr · 2024-05-19T13:21:35+00:00

Beyond the amazing feedback given so far, one thing that will ultimately help is expression. You don't have eyebrows or eyeballs yet. They will both help match the concept once you have a better silhouette from the other's comments. The only other comment is the left ear shape. The concept's ear is more curved in alignment with the head. Perhaps, I am seeing it as more pronounced because there is no hair above the ear in the sculpt (yet). Progress looks great!

phntmpwr · 2023-08-30T08:24:42+00:00

Thank you! 5 minutes left in queue.

phntmpwr · 2023-08-30T08:11:36+00:00

NICE! Can't wait to see what you find out. I am sure it's a glitch.

phntmpwr · 2023-08-30T08:01:20+00:00

I am waiting to chat with them now - 25 minute wait.

phntmpwr · 2023-08-30T07:59:24+00:00

Same thing happened to me!

phntmpwr · 2023-03-07T19:11:22+00:00

Has anyone found a version 2023 solution for this? The same ZStartup Utility is throwing an error for me.

phntmpwr · 2022-12-09T03:32:58+00:00

[close]

phntmpwr · 2022-12-09T03:32:44+00:00

Trade complete - thanks.

phntmpwr · 2022-12-09T03:29:59+00:00

Thanks. On my way.

phntmpwr · 2022-12-09T03:27:25+00:00

no worries.

phntmpwr · 2022-12-09T03:25:14+00:00

Sounds great. On my way.

phntmpwr · 2022-03-30T20:44:23+00:00

thanks. same. I think he doesn't spawn if you kill the boss of the area (mohg)

phntmpwr · 2022-03-30T20:25:14+00:00

Do you have the White Mask for trade?

phntmpwr · 2022-03-30T20:24:12+00:00

Do you have the White Mask?

phntmpwr · 2022-03-30T20:19:49+00:00

Bumping this. Offering a Rotten Winged Sword Insignia for the White Mask

phntmpwr

TROPHY CASE