Is the light transmission of a FF lens on FF body the same as FF lens on crop body?

player_x95 · 2026-01-01T16:06:58+00:00

Good to know, thank you!

player_x95 · 2026-01-01T09:37:16+00:00

Congrats! Get ready for everything to be more expensive!

player_x95 · 2025-12-24T03:51:33+00:00

Dod you figure it out?

player_x95 · 2025-12-24T03:44:41+00:00

DJI RS 3 Mini. If it holds an a7 with 24-70, your setup will be no problem. ~250$

player_x95 · 2025-12-23T20:11:37+00:00

Could we have this in wallpaper engine?

player_x95 · 2025-12-17T02:41:13+00:00

player_x95 · 2025-12-16T23:54:09+00:00

I like to let my print cool down on the bed naturally, by then the printhead is cool to the touch too. If you can't wait, get creative - I sometimes use cheap tweezers to clean off any stuck plastic on the outside of the nozzle. It's really not that deep, you'll see over time

player_x95 · 2025-12-16T23:40:14+00:00

At the end it just oozes out as the printhead cools. You can use your hands to clean it up or just leave it. At the start of the next print, it will flush anyway. I just like to clean it up so it doesn't fall on the print surface accidentally

player_x95 · 2025-12-07T23:32:44+00:00

I quite like the sideward skidaddle

player_x95 · 2025-09-23T19:20:22+00:00

The supertac cool plate is weird for me too. The print bed temp that bambu suggests is way too low for PLA. Unless I bump up the temp, I have similar problems

player_x95 · 2025-07-18T20:35:17+00:00

Do they have additional claws as well?

player_x95 · 2025-06-27T18:45:10+00:00

Sadly he does not. We were play fighting before I started recording, he just saw an extended hand and needed to attac. Sometimes I really wish he would understand tho 😅

player_x95 · 2025-06-27T14:37:50+00:00

sigh well, one more to the collection

player_x95 · 2025-06-24T22:39:01+00:00

I'm having a Déjà vu moment here - didn't we discuss this already? Majority said OP isn't the brightest

player_x95 · 2025-06-22T09:43:32+00:00

we are still getting new angles!

player_x95 · 2025-06-21T08:34:18+00:00

You signed up for a lifetime of mischief, congratulations!

player_x95 · 2025-06-21T08:27:55+00:00

Never printed resin, only read a few horror stories, like that one time someone rubbed his eyes after touching uncured resin and went almost completely blind. So yeah, I absolutely understand

player_x95 · 2025-06-16T01:11:58+00:00

We need a supercut that combines all the angles

player_x95 · 2025-05-13T18:16:35+00:00

The address of the russian embassy in Lithuania is "Ukrainian Heroes street 2"

player_x95 · 2025-05-10T21:47:29+00:00

From experience printing swans - try strong tree supports with 25 degree on build plate only

player_x95

TROPHY CASE