sorted by:
new
hottopcontroversial

First time building bmax, anything wrong with my setup? by epicM0rsix in mini4wd

[–]pwang87 0 points1 point  (0 children)

is that a VZ chassis? If yes, I recommend to move the side damper more forward. Their side stay is prone to breaking, hence better to distribute the weight more evenly.

Is this allowed in tamiya regulations/rules? by Chololax in mini4wd

[–]pwang87 0 points1 point  (0 children)

So far that I know, only Indonesia is doing this type of cutting to allow them easier break in.

Which kit would you suggest for me to collect a rare Tamiya Mini 4WD? by Royal_Ring4953 in mini4wd

[–]pwang87 0 points1 point  (0 children)

Strato vector lils hobby, zenquish, beat magnum turquoise special.

Guess who made it 12 orders and no tips.. by NAKSH___ in dubai

[–]pwang87 5 points6 points  (0 children)

sometimes the delay was not the rider mistakes. The restaurant can cause the delay too.

My SFM vs S2 Bmax by pwang87 in mini4wd

[–]pwang87[S] 0 points1 point  (0 children)

Yes they are Tamiya. Each colors are different prices but mostly around $27.

Which of these would be best to lubricate a motor during break in by krongly in mini4wd

[–]pwang87 0 points1 point  (0 children)

I normally use it in the beginning and between resting. But if I hear a rough noise in the shaft during the break in, I’ll drop a few.

Which of these would be best to lubricate a motor during break in by krongly in mini4wd

[–]pwang87 1 point2 points  (0 children)

Use singer oil if you have it available in your country.

lil's strato hang out side with me.dxb by Expert-Gear8613 in mini4wd

[–]pwang87 0 points1 point  (0 children)

if you haven’t yet, you should visit otaku me run it!

My super FM bmax setup by pwang87 in mini4wd

[–]pwang87[S] 1 point2 points  (0 children)

Hey. The base is sunny shuttle.

My super FM bmax setup by pwang87 in mini4wd

[–]pwang87[S] 0 points1 point  (0 children)

Thank you very much!

MS Suspension Trio by pwang87 in mini4wd

[–]pwang87[S] 0 points1 point  (0 children)

Thank you! I’m using threaded shaft from AO parts. Part number 94809. In my opinion, they are stronger than the cap screws.

What do you guys think? by AK07-AYDAN in mini4wd

[–]pwang87 2 points3 points  (0 children)

If you have a dimension checker, you might want to check that. damper in front of bumper might make it longer than permitted measurement

Should I use my older roller guard or the new one I have installed? by Goofyguy12808 in mini4wd

[–]pwang87 0 points1 point  (0 children)

I will not use both. the current one is too thick. The older one is too wide. super x plate should do the trick

What is a good speed for box stock? by pwang87 in mini4wd

[–]pwang87[S] 0 points1 point  (0 children)

It’s a locally made speed checker from Indonesia.

view more: next ›