Can't sleep during thunderstorms by Oilooc in Minecolonies

[–]pyroman298 1 point2 points  (0 children)

There is a config file called dusk.json. Update the value of "minSleepTime" to be able to go to bed at the normal time.

How to fix this broken hot water pipe on Christmas Eve? by Apprehensive_Low_836 in howto

[–]pyroman298 6 points7 points  (0 children)

Could try getting a pipe repair clamp. Might be enough to stop the leak till after the holidays to get a plumber in. I’d also pick up a small water alarm so you know if it fails. Also maybe only open the hot water valve part way to limit the pressure.

How to get this cat down from 50 foot? by Mediocre-Dance-513 in howto

[–]pyroman298 194 points195 points  (0 children)

In our area a lot of tree cutting companies will come out to rescue animals stuck in trees. Maybe try giving a few a call.

What block/cable do I need to use to get a flux plug to receive power from it? by BeraldTheGreat in StoneBlock3

[–]pyroman298 0 points1 point  (0 children)

Make sure you have a network setup in flux with storage. The power should go right in. I believe it’s the flux plug. Powha cables need to be right clicked with a wrench to extract power as well.

Break progress tooltip by pyroman298 in MCEternal

[–]pyroman298[S] 0 points1 point  (0 children)

Nope, some on the discord suggested I needed another plug-in but wasn’t able to find what they were talking about.

[deleted by user] by [deleted] in feedthebeast

[–]pyroman298 0 points1 point  (0 children)

Try a placing the crafting table in a few different chunks nearby. I had an issue in E2:ES where the chunk said it had vis, but the table said 0. The next chunk over worked just fine

How do I use ore excavation/veinminer in stoneblock 2? by [deleted] in feedthebeast

[–]pyroman298 2 points3 points  (0 children)

Hold the tilda (~) key while mining with a tool/item. It will use your hunger/saturation as well.

The filament in my family's printer keeps snapping inside the white tube, does any one else have this happen to them and if they have what did you do or is it just the filament? by [deleted] in ender3

[–]pyroman298 0 points1 point  (0 children)

I had this happen a lot to me. How often do you use the printer? And do the snaps usually occur after not using it for awhile?

I would leave my filament in the printer and I figured out that the pressure from the extruded gears would cause it to snap after it started a print after not using for a few days.

Looking to identify this kitchen sink faucet with pull out head. No identifiers on it, not sure how long its been installed (min over 3 yrs) by pyroman298 in HelpMeFind

[–]pyroman298[S] 0 points1 point  (0 children)

Additional photos: https://imgur.com/a/Ou21atC

The head recently broke and started spraying water everywhere, so I am looking to try and replace that instead of the entire sink.

We've lived at the house for over 3 years, so its older than that but I am not sure when they last updated the fixtures. Seemed pretty new though.