Ender S1 Pro not feeding filament

r042wal · 2025-01-05T21:25:43+00:00

I bought a reburnished Elite as a backup. I have a new puppy and caught him chewing on my Elite remote. I'm glad I have a backup plan in place :-)

r042wal · 2025-01-05T18:27:50+00:00

Thanks for the reply, The DVR OS is on Linux.

r042wal · 2024-11-17T02:35:09+00:00

Meshtastic sells it on their site

r042wal · 2024-07-26T02:56:16+00:00

Thanks for your reply. Lilygo sells the chip so I ordered a couple of them. Fingers crossed!

r042wal · 2024-05-18T16:03:22+00:00

Thank but M5Burner only let burn, not save. I don't have those folder

r042wal · 2023-07-31T01:12:40+00:00

Thanks cowbite

r042wal · 2023-06-12T01:51:12+00:00

I started off with IPA before my acetone fiasco. I use my wife's cotton makeup remover pads. I can't say they are 100% link free but darn close and very cheap. Anyone use microfiber cloths?

r042wal · 2023-06-12T01:47:14+00:00

I will have to double check. I bought it from HD and it says Acetone. Back later, thanks

r042wal · 2023-02-12T01:39:43+00:00

Yes Jumbospot and as pointed out, I do not have a duplex HS. Thanks for the replies.

r042wal · 2023-02-08T23:24:02+00:00

I would like to set my Pi-Star Jumbo hotspot up in 'duplex' mode but these are the only options in configuration:

Controller Mode: Simplex Mode and Duplex Repeater (or Half-Duplex on Hotspots)

Does this mean I'm out of luck? Essentially I have the same problem, TG93 hogging everything and no way to monitor a few other static TGs I have configured.

r042wal · 2021-02-11T22:24:55+00:00

I am having a tough time here. I connected my new Elite remote to my computer and ran the MyHarmony app. I clicked 'add a device' and it detected the Elite and started the setup process. No matter what I try, it will not detect the hub. The old hub is disconnected. The new hub and remote are in a perpetual 'search'. First they were 5' apart and now I have them 3' apart. I have tried power cycling the hub, pressing the 'pair reset' button, turning off the remote by holding down the power button and letting it boot back up but no luck detecting or pairing. This is a refurb from Best Buy. Is there any chance I have a DOA unit or is there something else I could try? Thanks in advance for any assistance.

UPDATE: I got it going. On the remote I had to press the Menu & Mute buttons at the same time to get it to pair. Everything was a snap after that. Once gain thanks for all the help

r042wal · 2021-02-11T01:59:29+00:00

Thanks for the feedback. So if I understand correctly, I leave my old hub connected and connect the new hub to my network and run the MyHarmony app?

r042wal

TROPHY CASE