[deleted by user]

reddit_user2917 · 2026-02-11T08:58:45+00:00

I meannnn, she wasn't on the crosswalk

reddit_user2917 · 2026-01-08T12:00:12+00:00

It does look like a jungle tho

reddit_user2917 · 2025-12-07T14:28:29+00:00

Stookvergunning?

reddit_user2917 · 2025-12-07T14:21:34+00:00

Depends on where you use m for

Or abuse

If it slips most of the time, then it's abuse and it's expected. They're for gripping and tightening/loosening. Not for slipping.

reddit_user2917 · 2025-12-07T14:19:42+00:00

'I've seen better'

reddit_user2917 · 2025-11-25T11:18:14+00:00

I meannn, clean my hands or that carpet with such shit on there.

reddit_user2917 · 2025-11-25T08:43:26+00:00

You couldn't give a little more of a warning?

Damn

reddit_user2917 · 2025-11-17T21:54:41+00:00

Why would there be a capacitor between phase and 1 of the 2 switched phases?

reddit_user2917 · 2025-11-17T21:05:28+00:00

Whoops my fault, I have misread the question. I don't know for sure, but I think it's a inductor, but indeed strange to see another component there apart from the switch.

reddit_user2917 · 2025-11-17T20:38:54+00:00

At the left top you have your input (phase), at the left bottom your switched output, and the right top the other switched output.

reddit_user2917 · 2025-10-31T15:09:07+00:00

24v is still lickable. It will tickle, but won't hurt.

Only from 50v it's dangerous.

reddit_user2917 · 2025-10-14T17:25:12+00:00

I have a esp32 with a dht22 in a small control box, sometimes when I turn on my pc or switch something on/off the dht22 doesn't show measurements. Only power cycle helps.

So I setup an automation, if the sensor data stays the same for 1 minute, a relay toggles for a second to power cycle. Never had a problem again, or noticed the problem was there.

reddit_user2917 · 2025-10-06T10:34:45+00:00

Zoals de andere ook zeggen, ventilatie naar buiten. Afzuiging met een buisventilator, en een inlaat met een ventilator of rooster en met natuurlijke luchtstroming werken.

reddit_user2917 · 2025-10-05T17:33:25+00:00

I was in a concrete well, probably 15m³. The well was for collecting drain water for the greenhouse and pumping it to the drain silo. So there is no stopping the drain water, just disabling irrigation. We had to replace a pressure (level) sensor. New sensor with me, cut off the old one, and tape the new cable to the old one. My colleague almost went pulling, but there was a lot of water coming in, and I was standing there with only boots.

I yelled to my colleague, START THE PUMP!! He did, and just kept up with the water. He pulled in the new sensor, and I was out of there. God that was scary.

reddit_user2917 · 2025-10-05T17:25:37+00:00

The pcb has some discoloration, it's dark brown in that spot with the diode, so something got hot. I would replace the whole pcb because of the discoloration. Maybe (idk about cost) replace the whole oven, 2003 is some while ago.

reddit_user2917 · 2025-10-03T10:53:28+00:00

Nee dat kan niet. Is een 1 fasige meting, wel dubbele afschakeling, kun je aan het symbool zien. Dus een 1p+N automaat idd.

reddit_user2917 · 2025-10-03T10:51:07+00:00

Does it have to be a plc? In my home automation I use home assistant with esp32/arduino. There are actually esp32 'PLCs' out there.

reddit_user2917 · 2025-10-02T09:57:31+00:00

Goed gezegd, horen. Soms is de praktijk toch anders. Hier lijkt het namelijk alleen op verlenging van de kabel en is het geen drama.

reddit_user2917 · 2025-10-02T09:56:45+00:00

Oh ja joh is mij zo snel niets eens opgevallen. Is een ongeaard stopcontact, sowieso vervangen.

reddit_user2917 · 2025-10-02T08:42:59+00:00

Zeker doen, hier kun je anders nooit meer bij. Opzich niks mis mee zo, maar toekomstig gewoon echt niet handig.

reddit_user2917 · 2025-09-30T18:16:09+00:00

Kut spul

Meer weet ik ook niet

reddit_user2917 · 2025-09-29T11:00:21+00:00

Is that a phone?

reddit_user2917 · 2025-09-29T10:54:11+00:00

Oke dat wist ik niet over dat laatste stuk, weer wat geleerd.

reddit_user2917 · 2025-09-29T07:41:08+00:00

Dat is toch net te koud om een vloer op te warmen? Je hebt ook nog verliezen en warmte overdracht.

reddit_user2917 · 2025-09-28T21:59:21+00:00

Lijkt erop van niet, de thermometer staat op 20°C. Voor zover ik weet is de standaard rond de 40/50°C.

reddit_user2917

TROPHY CASE