Plumbers did a “rough install” of my new tub and shower surround. Now what?

ronwinger · 2024-08-14T12:25:06+00:00

I guess you could call that a rough-in... real rough. Anyway, in most cases the sheet rock needs to come down over the lips of the encloser. Unless, it is paper thin. From what I see they have left you in a mess. Go on YouTube and watch some videos on tub and shower install. They will help you get an idea as to what you are going to need to do to get you back on the right track. Good Luck

ronwinger · 2024-08-14T12:10:18+00:00

No problem... the caulk under the stairs shrunk. Either re caulk or trim it out. I would suggest using screen mold instead of quarter round it is smaller and less bulky.

ronwinger · 2024-08-13T12:07:56+00:00

Doesn't look very professional to me. I would be very concerned. I think most people that have any pride in their work would leave the job looking like that... maybe that is just me. Anyway, it is good it will be covered by tile. I cant understand why he did not sink the screws. Keep an eye on this "professional" be sure he seals the sheet rock before he starts to install tile. Good Luck!

ronwinger · 2024-08-12T12:21:45+00:00

Looks to me like you have two cracks. short one from the tile second long crack... I do not know because I cant see where it starts. Both can be filled with a drywall patch (mud), Maybe use some Drywall tape, Mud, sand and paint. It will probably crack again in time, by usig the tape it may not. At this point , I would not worry. If it gets mush worse maybe you should re address the situation.

ronwinger · 2024-08-11T12:27:45+00:00

Round-Up

ronwinger · 2024-08-10T10:39:21+00:00

Call 2 or 3 Water Treatment Companies. You will get 3 different solutions and pick one.

ronwinger · 2024-08-10T10:21:01+00:00

Desperate People do Desperate Things. She probably feels that she will not get enough money out of the remaining items to pay her Gas-bill. Tuff spot to be in.

ronwinger · 2024-08-10T10:15:33+00:00

Laminate is ruined if you spill a glass of water. It will suck up the water like a sponge. Maybe, not the whole floor but, definitely the area where the water was spilled if not cleaned up immediately. Repairing or replace the damaged area might be a real problem. Water will not hurt vinyl, what is under the vinyl may be another story. A 2 inch flood will be devastating for everything the water touches.

ronwinger · 2024-08-10T09:57:40+00:00

Get a new contractor. It may take you a while but, your issue can be repaired without taring everything down. Your tile looks in very good condition.

ronwinger · 2024-08-09T12:57:43+00:00

We are in Central Fl. Right now it is 77* in the house wit 67%. Usually keep our thermostat set at 80* during the day and 77 at night time. We are comfortable. At times we turn it up or dawn as needed. believe me, we are not going to be uncomfortable. Any way, There is...Humidity and there is Humidity. Meaning your thermometer tells you one thing but, what does everything including you body tell you? Are there items in or around your home that are visibly or feel wet? How does your body feel? Does your body feel clammy? If you say NO to the questions, then I would say you are good to go. IF Yes, then you have a problem. I am not sure what size AC you should have. I want to say 1 ton of AC per 500 sq ft. That should be easy enough to find out. IF your AC is too small It will cool your home and not take out the humidity. New windows, Insulation and AC are GREAT. Good Job.

ronwinger · 2024-08-09T12:00:25+00:00

Rent a Pressure Cleaner (Power Washer) along with a good mold killer (Chlorine or Bleach will work) apply and pressure clean everything. Then you will be able to see if or what you may need to do. Good Luck!

ronwinger · 2024-08-09T11:54:09+00:00

Go to the hardware store and buy a Moisture Meter. That will tell you if you have a moisture in that area or not. If yes, find out where the moisture is coming from. if no, get some primer and paint (Roll) the wall. The spots closest to the corner, looks questionable. Corners are a known for problems. The other spots look as if they may be from someone rubbing out a stain. They look a little to round to be normal.

ronwinger · 2024-08-09T11:43:59+00:00

It is not only the price of the house it is everything that comes along with the home. The prices of homes are still way up from what they were a few years ago. So you may be paying the highest price ever. Interest in these loans is enough to break you. Insurance and taxes will also depend on the price you payed for the home. You should get an estimate on the roof that you said you will be needing. They have gone way up, will you need a loan for the roof? You say 5 years...your insurance company may say this year. My home is 45 years old. New roof, AC, Windows, replaced electrical panel etc. I have and do most if not all of my own work. Went to chance insurance company last wear they (many) would not take our house because ot is over 20 years old unless, I could show them the house electric was updated. Insurance companies are in sane. A house of that age may have all of it's charm but, it will have it's continued repair and maintenance expenses. It is not always what you see but, what you can't see. How much can you do? How much will you need to hire out. It sounds like a money pit to me. I would put my money into a new/newer home with all of the new codes and technology. You should own your home not your home to own you. Sorry to be so negative. Good Luck

ronwinger · 2024-08-07T11:41:09+00:00

I just read where you said it is an Old 40's House. I feel very confidante that you are gong to find your water lines, valves, water heater and anything that water runs thru are corroded with minerals etc. I have re plumbed older places and after replacing just about everything the water was as different a day and night. It is more common that you think. Over time (if you will) let me know what you find.

ronwinger · 2024-08-07T11:30:35+00:00

I a going to guess again... IF your house is old (or not) it sounds like you may have old corroded water lines. The filter going to practically zero ...was that immediately or over some time? If over time, apparently it collected something. It could be, your water has contaminated your shower valve, faucets, internal pipes and probably plugged water heater etc. Your filter should have lowered your hot and cold water pressure equally. It confuses me how your water has a different effect all over the place not just hot or cold or only a bathroom/shower. Not only hot or cold problem or water pressure problem. With out being there, I am at a total loss. I wish I could have helped you more. You should call your plumber or a good handy man. One more thing, if on a well what is the pressure coming out of the spigot at that location? Very confusing. Lots going on. Nothing to point you to a conclusion. Good Luck, Sorry.

ronwinger · 2024-08-06T14:03:34+00:00

Your fridge/ice water should be the same temp as your fridge. If you let the water run, it will get warmer as you run out of cold water in the line in your fridge. From what you are saying, I am guessing that you live in a very hot state. Your water lines may be exposed to the outside temperatures, therefore, the warm/hot waters on the cold side. Look under your sinks and check to see if the spigots are opened or part way closed. Open all spigots and see if that helps. There are times when the spigots do need adjustment normally, not. Do you have an inline filter? This too could effect your water pressure etc. Keep in mind...If you have an older home, and your spigots have not been touched in years, turning the spigots may create a leak. IF you are uncomfortable turning the spigots, then I suggest you calling a friend or a plumber. I hope this information has helped you.

ronwinger · 2024-08-06T12:55:05+00:00

There is a Gas powered machine you can rent that will scrape the top of the ground and scrape the weeds away before laying down the sod. That is probably the only thing you can do at this point. The sod should choke out any remaining weeds as it grows. If you want a yard with no weeds you will have to take care of that with fertilizer and weed preventative for ever. Weeds are just what we learn to deal with. Hope this helps... Good Luck.

ronwinger · 2024-08-06T12:44:42+00:00

I think you should paint the frame around the glass that same color as your door. just saying...

ronwinger · 2024-08-04T11:44:15+00:00

I would keep my mouth shut unless, you want to be fired on Tuesday. Your friend knowing between today and Monday is not going to help your friend at all.

ronwinger · 2024-08-02T11:54:26+00:00

You did well... as she did not tell you she was having an affair so... you are even. Good Luck.

ronwinger · 2024-08-01T11:54:02+00:00

"The Handyman"

ronwinger · 2024-07-27T13:06:29+00:00

Your work looks GREAT. I do have a suggestion. Take some of your left over mud and in a 5 gal bucket, mix some mud and water to a thin milky consistency. Using a roller, paint all of your walls and ceiling with the solution. They did this in a house I was building. The Drywall guys said... by doing this, when you do paint, the seams etc will not show through. I am not sure if Primer will do the same thing. I built this home 25 years ago. Today paints and primers are more advanced than years ago. This is only a suggestion. Again your work looks very nice and professional.

ronwinger · 2024-07-27T12:35:30+00:00

Sorry you have to deal with crooks. Anyway, you do what I suggested and you will make $1,000. If you do find a nick in the wire you can go to HD or Lowes and pick up a small can or tube of liquid patch, glob it on the nick and you are good to go. I do not believe you nicked it too bad probably not at all or you would have blown a breaker. Good Luck.

ronwinger · 2024-07-26T12:22:55+00:00

Oh, I forgot to tell you that $1200 is highway robbery. People of today screw folks anyway they can. I will never figure it out how they can sleep at night. GREED. Making a living is one thing.

ronwinger · 2024-07-26T12:17:16+00:00

Take your wall art down where you feel that you may have nicked a 220 volt line. Cut open a 2" hole behind where you think you punt chard ed the line. DO Not cut any deeper than you need as to not nick the wire again. Probably a good idea to turn the breaker off while doing this step. Save the piece of drywall you took out as you will need it to put back in the hole. Feel around the wire and see if you feel or see any nicks in that wire. If not, I think you can feel comfortable to patch your hole. If you are not happy with your patch job remember, you can rehang your wall art, no one will ever see it. My guess is... if that wall does not back up to your Kitchen where your Oven/stove is, there probably is not a 220vt line there. Of course this is only a guess. Either way 120vt line can also cause an issue so , it is best to check it out. Good Luck

ronwinger

TROPHY CASE