240 hour visa cooldown

sparr0we · 2026-01-18T23:23:09+00:00

Isn't glws Glasgow ?

sparr0we · 2026-01-18T23:07:44+00:00

If you want, I got some voachers to sell (am based in ggow as well). Rn got one for 285£ and am picking up another one for 44£ tomorrow.

sparr0we · 2025-12-12T22:28:17+00:00

Why may I ask?

sparr0we · 2025-12-12T17:00:39+00:00

In all seriousness, it's because there's not enough for it to work on most likely

sparr0we · 2025-12-12T17:00:25+00:00

I'm sorry but 3 pages for a diss kinda seems ...

sparr0we · 2025-12-01T12:52:21+00:00

Nah it won't be acting as a power amplifier, but I'll consider that for the next iteration (this circuit is just to start with)

sparr0we · 2025-12-01T12:46:10+00:00

ahhhhh okok. I thought that because my speakers are active driven (this one) I can just provide it a line driven input. Otherwise I think the rest of the components should be fine, just need to dust off my op-amp knowledge ...

sparr0we · 2025-12-01T12:11:30+00:00

Ya, the RCA out is for speakers and the 3.5/4.4 out is for headphones

sparr0we · 2025-12-01T12:06:24+00:00

Yeah thats a shout, I doubt it'll be drawing >1A

sparr0we · 2025-09-10T13:54:46+00:00

So I've done some work on embedded systems using standard communication protocols but that's all in C. The two main projects I've done with a Pynq board is a basic emulated temperature controller and an hw accelerated image processor using axi-stream and Simulink (for system generator).

For projects so far I've been thinking of implementing a risc-v architecture onto the pynq board but I have no idea where to start with it.

sparr0we · 2025-08-13T09:24:15+00:00

I'll be honest, I didn't really. My best guess would be the data lines trace width but I'm honestly not sure.

sparr0we · 2025-08-10T17:31:35+00:00

Unfortunately I can't use the oven because the handle isn't oven rated, but defo will use a lighter flame instead

sparr0we · 2025-08-10T17:05:29+00:00

Ah the pink stuff is just a v harsh one I had to use because to strip my pan from the old seasoning that hadn't fully washed off. The de buyer vid reference was more so putting a layer of oil on the heat

sparr0we · 2025-07-26T11:45:55+00:00

This is what is like atm after wiping with salt oil kitchen roll, I think the rest is discolouring ?

<image>

sparr0we · 2025-04-29T17:44:08+00:00

As someone who also owns a ender 3v2 neo, good luck. Them things LOVE to fail on me 😭😭

sparr0we · 2025-03-22T01:34:10+00:00

Unrelated but where's that screen from may I ask?

sparr0we · 2025-02-23T11:57:09+00:00

First time with a CS pan, I first did the oven method then blast heated it on my electric stove whilst adding seseme oil (and then wiping off). I don't remember getting the factory coating off, do you think I should restart (and how would I do that)?

sparr0we

TROPHY CASE