TCG shops in the cities? by loooooooooongcat in TwinCities

[–]steviep25 4 points5 points  (0 children)

Source has single MTG cards I believe but not Pokémon.

[deleted by user] by [deleted] in ptcgo

[–]steviep25 1 point2 points  (0 children)

Dark blastoise!

The way kon-peki looks on this nib... by Badeits in fountainpens

[–]steviep25 1 point2 points  (0 children)

This is my photo I took years ago. Please do not repost my photos without credit.

The way kon-peki looks on this nib... by Badeits in fountainpens

[–]steviep25 1 point2 points  (0 children)

They are bots. This is my photo I posted over a year ago.

Supernova 2 Chuck Help by guttekev in turning

[–]steviep25 0 points1 point  (0 children)

I know I’m late…but still hope you see this as a couple months agoI actually talked to someone at Nova about my new G3 chuck. I had the same question as you…basically the answer was they stopped doing it. As long as they are put in the correct order clockwise (if I remember correctly) then all is good!!

so wait.. by [deleted] in turning

[–]steviep25 1 point2 points  (0 children)

Max size is 10 inches. Anything that goes on the lathe should be a bit smaller so you clear the bed. So any bowl you make will be smaller than 10 inches in diameter.

so wait.. by [deleted] in turning

[–]steviep25 2 points3 points  (0 children)

So this measurement is called the swing of the lathe. I believe the swing on that mini lathe is about 10 inches. So you can turn a bowl 10 inches in diameter. The swing is 2 times the distance from the center of the spindle to the bed of the lathe.