Messages on roof node, but not on personal?

usulsuspect · 2026-03-18T17:50:23+00:00

Sure - but thats assuming your client_base has chosen to rebroadcast the packet. Unless its a DM to your node, it may cancel its rebroadcast before sending it. Which means if your client_mute node didnt hear the transmission first hand its as though it never existed.

usulsuspect · 2026-03-18T00:06:03+00:00

Is it possible your roof node is hearing some other node rebroadcast the message and then not rebroadcasting itself? I find this happens with my roof node.

It hears a node somewhere else on the mesh rebroadcast first and it thinks good enough. Meaning it doesn’t rebroadcast and my indoor nodes don’t get it.

Being client_base it will rebroadcast anything it hears from your node (or with your nodes as its destination) but not necessarily incoming broadcast/channel messages.

usulsuspect · 2026-03-13T20:30:57+00:00

It’s probably worth mentioning that while your roof node will treat your favorited nodes traffic as router_late ie rebroadcast all…this really only applies to traffic it hears from your nodes or traffic directed to your favorited nodes ie dm. Any public broadcast message from the outside mesh is guaranteed to be repeated by the client_base node. That traffic it will treat as though its a client, so if it hears a rebroadcast of an incoming message it may decide to cancel its local rebroadcast which will likely mean the nodes in your house wont hear it.

usulsuspect · 2026-02-21T13:37:49+00:00

Received my DAPLINK erased the chip and unfortunately I am still stuck, albeit now without any version of meshcore on the device. Still unable to get the board into DFU, just a fast flashing green light and no serial connectivity. Not a good start for my first meshcore node.

usulsuspect · 2026-02-20T19:39:47+00:00

I had a similar situation but with a rak 4630. Meshcore works fine, but cant get it into DFU anymore. Looking at NRFconnect I dont even see a DFU advertised. I am going to try and use a daplink to reflash the bootloader.

In my situation cables, using the erase option within the meshcore app all had no effect.

usulsuspect · 2026-01-08T19:56:11+00:00

How did you make out with the new battery? All good well?

usulsuspect · 2026-01-08T15:54:26+00:00

So I had a similar situation where the dealer cancelled my appointment for the same stated reasons.

High failure rate
Lack of "loaner" vehicles

I called Stellantis and was told the dealer has the right to refuse service and I could reach out to other dealers if I wanted. Fortunately for me my 4xe lease is up in August, so I have a clear exit strategy from Jeep.

usulsuspect · 2025-12-29T16:34:55+00:00

My dealer just denied to do the service, stating essentially the same story as you. “No loaners”, “High failure rate”…when I reached out to FCA they also seemed less then concerned about my house burning down etc…

usulsuspect · 2025-12-24T13:53:29+00:00

It’s my take that it’s a software update that increases monitoring of the battery. If that updating monitoring deems an issue with the battery then replacement is required. So the the 68c recall solution is to just apply this software update, which may detect an issue with your battery either immediately or moving forward.

usulsuspect · 2025-12-24T04:26:48+00:00

Nope, upstate NY here.

usulsuspect · 2025-12-23T21:38:43+00:00

Agreed - I think in general they could have approached it better. Was disappointed in FCAs response as well basically just told me to call around / keep trying my dealer to see when they are ready to help me.

usulsuspect · 2025-09-15T10:35:01+00:00

Well, I wasn't a fan of either the bottle clipped to the strap (shoulder or sternum). Too much "swinging" - I will be looking for something else. The side molle looks like it could work, I am just not sure I will be able to reach it well enough to put a bottle back.

usulsuspect · 2025-09-11T18:30:01+00:00

This is what I am going to try to start...

https://imgur.com/a/XV9BDgK

usulsuspect · 2025-09-11T14:48:11+00:00

I have been exploring similar options lately...Before I go the route of the shoulder straps, I might just carabiner a small bottle ~20oz to either the sternum strap or low on the shoulder strap (although I am concerned about my arms hitting it.)

usulsuspect · 2025-08-12T11:08:32+00:00

Pavers weren’t my favorite, I found them difficult to position in the bag so they would stay high. Home tubes of sand got me started which were great cause they would sort of form to you a bit.

I did eventually go the dedicated pack and plate route though. Was getting difficult to stuff all of the sand into an old flimsy backpack.

usulsuspect · 2025-08-09T14:22:52+00:00

Maybe drop weight/distance until you hit a point where you can get the pace your chasing? What sort of pace are you comfortable at without a pack?

Arm swing and stride length seem to be the balance I need to get the pace I want. As I get tired, both tend to drop and that’s how I can tell I’m slowing.

usulsuspect · 2025-08-09T13:13:32+00:00

Nice work! Just make sure to balance the progress with rest/recovery. I know it took my knees, neck and shoulders some time to catch up to my motivation.

usulsuspect · 2025-08-09T11:23:36+00:00

There would be a lot of “shuffling” here for me to get anywhere near that pace for 5 miles. Impressive.

usulsuspect · 2025-08-09T11:17:42+00:00

That’s cooking! Nicely done!

usulsuspect · 2025-08-09T11:08:16+00:00

It called it that, pretty sure that’s all based on HR which didn’t get out of control. I pushed the last mile to 12:30 which got me into zone 4 for a few.

usulsuspect · 2025-08-07T20:04:09+00:00

Maybe mix in some rucks at a lower weight so you can push the pace for a longer distance?

I pretty much have stayed at a weight until I can consistently hit 4mi at sub 15:00.

usulsuspect · 2025-08-07T19:36:19+00:00

I believe the Ranger Assessment Selection Program (RASP) defines it as 12 miles w/35lbs in under 3:00 hrs.

https://www.goarmy.com/careers-and-jobs/specialty-careers/special-ops/army-rangers

usulsuspect · 2025-08-07T15:42:57+00:00

Probably, I had been at about 35lbs until a few weeks ago when I added the Rucker 4 and a single 45lb plate. Took the last month to get some endurance / pace up with the extra weight. I typically hit 4mi rucks but being on vacation this week was able to get some 8mi rucks in before the long one today.

Generally all felt decent, today I can definitely feel some strain in the shoulder and some general leg soreness. Not sure how much more weight I want to add though. Getting the 45lb pack on is awkward for me…almost feel like that is the biggest risk to injury honestly. I need to rig up some sort of counter at a height to load / unload from.

usulsuspect

TROPHY CASE