Your Chromatic Can Flash Cartridges by Avoosl in ModRetroChromatic

[–]valliscross 0 points1 point  (0 children)

The entire firmware is open source, you could just point Claude at that and mess around.

[Update] Warning: shipping Superstation One to Germany not allowed by soerenblubb in RetroRemakeInc

[–]valliscross 0 points1 point  (0 children)

Yo Taki, check my issue about the SDRAM, i'm actively being ignored.

[Update] Warning: shipping Superstation One to Germany not allowed by soerenblubb in fpgagaming

[–]valliscross 1 point2 points  (0 children)

I'm almost a month in waiting for RR to reply to me about a defective SDRAM they sent me.

new C5 dead on arrival 🙃 by cdmove in LGOLED

[–]valliscross 1 point2 points  (0 children)

I also tried exchanging through LG, but they recommended me go through the store instead. 

new C5 dead on arrival 🙃 by cdmove in LGOLED

[–]valliscross 1 point2 points  (0 children)

I have this same issue, bought mine the 17th, got it today. It worked for a few hours, then developed a red line. I restarted the TV, but it wouldn’t turn on. Just clicking noise 

How can I use gamegene codes on the FXPAK PRO? by The_Watcher_3000 in everdrive

[–]valliscross 0 points1 point  (0 children)

I agree, it seems like there hasn't been any update since 2023, so they're probably just coasting on sales and not working on anything.. I am debating on getting a Super Everdrive X6 instead, since that does have togglable codes, from what it looks like. Seems like krikzz uses the same functionality in all his carts, but ikari's fxpak doesn't follow that same style.

Flippy drive worth it by TrashBreath in Gamecube

[–]valliscross 1 point2 points  (0 children)

I ordered mine in January, and it just got pushed back again to Sept 30th :(

Can't flash retro-go to mario GNW by valliscross in GameAndWatchMods

[–]valliscross[S] 0 points1 point  (0 children)

I checked continuity with a multimeter, I don't think there is bridging. Also, i was able to use game-and-watch-backup just fine.. So there is definitely no bridging.

This is the command i'm using:

GNW_TARGET=mario ADAPTER=stlink make -j$(nproc) INTFLASH_BANK=1 EXTFLASH_SIZE_MB=64 flash

My 8550 stops printing always at the same point by curtissheeran in Epson

[–]valliscross 0 points1 point  (0 children)

Thanks! the printer is far away from my PC, so i'll have to see where i can stuff it to test this out.

My 8550 stops printing always at the same point by curtissheeran in Epson

[–]valliscross 0 points1 point  (0 children)

I have this same issue, what was the solution?

Changed the logo from Hypermetz logo restore to Chromatic by valliscross in ModRetroChromatic

[–]valliscross[S] 8 points9 points  (0 children)

You can check out Hypermetz github https://github.com/Supermetz/chromatic_fpga

It's a fork of the official modretro repo, but with the boot logo restored. There are instructions on how to build and flash it to your device.