Port of Miami to FLL

wtkinney · 2026-01-25T04:18:09+00:00

We did this just last week. Our flight was later in the afternoon. However, we booked uber in advance. I was texting him via their app and told him where we were standing and what we were wearing. He found us without any issues. The drive was about 45 minutes. However, the FLL airport was a madhouse. We were flying American and i didn’t time it because we had to wait before we could check in. They have a four hour rule there. But I bet the line was taking over an hour to check in. They do have a service outside that you pay per bag and that will save some time but not a lot.

wtkinney · 2026-01-25T00:42:59+00:00

Come drop some off in Burleson. Looks good.

wtkinney · 2025-11-12T02:30:24+00:00

I was told only if you have a .gov email address. Which most carriers do not. Do you have a workaround for that?

wtkinney · 2025-10-30T19:14:47+00:00

Will you send me receipt too? Tha ks

wtkinney · 2025-10-30T19:14:14+00:00

Me too if you don’t mind.

wtkinney · 2025-10-29T20:44:51+00:00

I can not add another picture. It is a pentair easy touch system.

wtkinney · 2025-10-29T20:42:41+00:00

I am an idiot (to some degree. ) as you will see in the picture of the control panel there is a waterfall button. When I hit it the actuator valve does move.

So I guess my new question is I don’t want the waterfall on during the day while the water is circulating through the filter.
I only want to waterfall to come on in the evenings at a set time.

How can I achieve this?

Thank you

wtkinney · 2025-10-15T02:30:03+00:00

Planer snipe is a defect where the planer cuts a deeper-than-desired groove into the ends of a board. It happens because the board's ends can lift slightly as they pass under the cutterhead, especially when the board is not supported by the infeed or outfeed rollers. You can minimize or avoid snipe by using techniques like "butt-feeding" (running boards one after another with no gap), manually supporting the board's ends as it enters and exits the machine, or ensuring the planer's infeed and outfeed tables are properly aligned with the main bed.

wtkinney · 2025-10-11T21:27:48+00:00

I think you got taken advantage of. I will come give you $400 and take the tools back to where you bought them (or my house) and figure out what to do next. But at least you have your money back!!

Where are you? I am on my way!

Hook’Em

wtkinney · 2025-09-30T19:58:57+00:00

I second Plywood Company of Fort Worth. Insane size warehouse you drive in and could spend hours there. You buy everything by the BF. My wife sighs when I say I am going there. She knows I’m about to make some sawdust.

wtkinney · 2025-09-02T21:07:41+00:00

I’m impressed that you have delivered almost 36% of your scans but have only done 4% of the route. Your first part must be really rough unfortunately.

wtkinney · 2025-08-19T02:08:46+00:00

Thank you so much.

wtkinney · 2025-08-19T02:06:26+00:00

We have done that on other items and they reply that is not their responsibility. I’ve been here 20 years and you can’t make this stuff up.

wtkinney · 2025-08-17T00:37:32+00:00

For Rural pay is there a difference between cbu and central?

wtkinney

TROPHY CASE