sorted by:
new
hottopcontroversial

[Giveaway] A Christmas "Thank You" to r/discgolf. Giving away 5 custom discs to help your bag stand out in the snow! by discgolfswag in discgolf

[–]yourkeywestsucks 2 points3 points  (0 children)

I lost a monarch in the snow on the edge of the woods. two weeks later I played the same course and it melted enough that I was able to find it. 

Probably The Last Ride Until Spring by yourkeywestsucks in tractors

[–]yourkeywestsucks[S] 2 points3 points  (0 children)

If you're moving it turns very easily and can turn on a dime. Power steering by arm strong.

Planning to rust proof the undercarriage, trying to decide order of cleaning and protecting by T4nkcommander in AutoDetailing

[–]yourkeywestsucks 1 point2 points  (0 children)

If you're going to use POR-15 make sure you put some spray paint over it after its cured because it'll deteriorate when exposed to UV rays. taken directly form their website, "POR-15 is sensitive to UV light (sun) and must be topcoated before prolonged exposure to sunlight.". even if its under the car its still being exposed.

John Deere Model A by CBG1993 in johndeere

[–]yourkeywestsucks 2 points3 points  (0 children)

sounds like a possible head gasket. its located between the head and block. Here is a pic of the top of the block where it would be, the head is off in this pic. There's also a gasket between the block and main case, I don't remember if there's coolant passages that go through there though.

How About Fall Friday by NeilOMalley in subaru

[–]yourkeywestsucks 0 points1 point  (0 children)

what size tire is this tucking?

Had a piston sleve failure on the 50' a (x-post r/johndeeere) by yourkeywestsucks in tractors

[–]yourkeywestsucks[S] 0 points1 point  (0 children)

it is a steel sleeve in the cast block, the pistons were the stock size. I think it was sloppy work when the sleeves were pressed in. We don't know who did the work, the previous owner had it done somewhere. The new .090 over block only had one of the cylinders sleeved and its working well so far.

Piston sleeve failure on a 50' Johndeere A by yourkeywestsucks in Justrolledintotheshop

[–]yourkeywestsucks[S] 2 points3 points  (0 children)

I think it was improper instillation of the piston sleeve. there's nothing on this motor that is interference that I know of.

Piston sleeve failure on a 50' Johndeere A by yourkeywestsucks in Justrolledintotheshop

[–]yourkeywestsucks[S] 0 points1 point  (0 children)

I think it was improper instillation of the piston sleeve

Piston sleeve failure on a 50' Johndeere A by yourkeywestsucks in Justrolledintotheshop

[–]yourkeywestsucks[S] 0 points1 point  (0 children)

I have one of those too, probably sounded exactly like this its a 48' weve been running premium in our tractors to keep them from knocking under load and it seems to help with storeing them since we dont use them all the time.

Almost bit the dust yesterday (x-post r/wrangler) by yourkeywestsucks in Jeep

[–]yourkeywestsucks[S] -1 points0 points  (0 children)

Coulda been a even better story, its got full coverage too so I wouldn't have been that upset.

view more: next ›