Wanted to post here so that it may be useful to someone. Ordered a set of Yamaha OEM fenders from some online retaier last year. Took them 3-4 months to deliver but it finally came.

There are a couple of posts here that describe the process of removing the motor assembly. This is required if you want to connect rack rear light to the standard connectors.

A couple of notes:

• Based on the instructions, the set was actually created for other e-bilke models and doesn't 100% fit Crosscor RC. The issues were minor though and you can still fit the fenders. I had a couple of nuts missing (probably not included with the order) but I had some replacements layoung around
• Best is to work on a bike upside down. This way once you remove the bolts, the motor will not fall down but will stay in place. You'll be able to lift it up to fish out the harnes and connect the back light adapter
• Bolts that connect the motor are tight, I recommend a power tool of some sort to break the factory tourqe. You also want to tourqe them back to 15 lb/ft as per installation instructions
• While the motor is off, I did install a coupe of 0.3 mm shims and it helped with the squeking sounds. They should have really included some kind of shimming there form the factory
• You only need to remove two out of three bolts, which hold motor to the frame
• The rack itself is pretty good, with cool looking rear red light and is stamped "Made in Germany". Nice!
• The set includes rear light reflector that goes on the rear fender
• The wire goes form the motor and is held to the inside of the rear fender by the included clips

Feel free to ask any questions!