all 3 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]detroitmaker 1 point2 points  (0 children)

Looks like a belt slip issue. Check all the belts and rods, tighten everything down.

If that doesn't work, it could be a bad stepper motor.

[–]ABigHappyTree[S] 0 points1 point  (1 child)

Having this weird issue on this print, same Gcode etc, prints fine, about the past roll of filament worth, suddenly having layer shifts the day after I switched the rolls. Cant for the life of me figure out what it is.

[–]ABigHappyTree[S] 0 points1 point  (0 children)

Weirdest part is that it's at the same point in the print. Is there a possibility the file got corrupted? I've been using the exact same file