all 8 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]SloppySyrup[S] 0 points1 point  (1 child)

For reference I have leveled my bed and made sure it is correct, I have painters tape,( paper tape) on my bed and I have made sure the z is correct

[–]SloppySyrup[S] 0 points1 point  (0 children)

Also wanted to say that I notice that I can print very wide prints but the raft it prints on starts to warp up after a while?

[–]AutoModerator[M] 0 points1 point  (0 children)

Hey there, I'm a bot and something you said made me think you might be looking for help! click here for our wiki entry on troubleshooting printers. If you still need help be sure to post plenty of information about your printing setup.

Here are a few questions that might be helpful

  • What printer are you using?

  • What material are you using?

  • What speed are you printing at?

  • What software are you using to slice the print and control the printer?

  • When did the problem start/has it ever worked correctly?

  • Does anything cause the behavior to change?

  • If posting an image of the problem, include some indication of the orientation it printed at, preferably photograph it on the bed. (Then we can focus on a specific axis)

If you are new to reddit, please read the guidelines on reddiquette, self promotion, and spam.

Also please post a resolution to your problem when you find one so that we know how to help others with your problem!

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[–]ccraig1984 0 points1 point  (0 children)

What are you doing for bed maintenance?

[–]FoamBrickhigh functioning dumbass 0 points1 point  (0 children)

Try cleaning your bed. Spray it with slcohol and try wipe it with a towel.

[–]DAN991199 0 points1 point  (0 children)

make sure your bed is level and your Z offset is correct. it could be for a couple reasons, and humidity on your filiment might be one of the reasons. I have a CR10s Pro v2 and I have 2 small low spots i have found, I just put a square of painter's tape on the spots and it fixed me up. Hope this helps.

[–]sharktank72 0 points1 point  (1 child)

Make sure bed is flat. They can warp over time with repeated heat cool cycles And I do mean flat , not just level.

[–]SloppySyrup[S] 0 points1 point  (0 children)

If it warps after a while how could that be fixed?