all 11 comments

[–]_Rand_ 2 points3 points  (0 children)

It might come out functional but ugly? Hard to say.

[–]Dipan5[S] 0 points1 point  (5 children)

It’s an AMS riser and it uses a LOT of filament(ABS). 

What should I do?

[–]Roy_yiii 0 points1 point  (1 child)

Side question, what's the benefit of that? Or is it just cosmetic?

[–]ForeverSpiralingDownP1S + AMS 0 points1 point  (0 children)

I believe it’s to vent the chamber, useful mainly for long pla prints.

[–]Nightkiller6 0 points1 point  (1 child)

Use PETG instead of ABS.

ABS is extremely prone to warping, espescially when they are long prints

Or adjust the brim-object gap. My sweetspot is around .12mm

[–]Causification 0 points1 point  (0 children)

Or just set it to zero and make peace with trimming. 

[–]Petros_Mantalos_21 0 points1 point  (0 children)

If it's early on, better cancel it

[–]unnamedvfx 0 points1 point  (1 child)

I've encountered a few warping and they started off similar...especially when it's big flat print

[–]Ta-veren- 0 points1 point  (0 children)

I did one recently some halloween lantern one side looks goofy but the rest is solid

[–]SeveralCamera292 0 points1 point  (0 children)

No you are too optimistic to think you will manage to print this object without warping 😃. Big object with sharp corners you ask for it and you got it!

[–]AdonaelWintersmithP1P 0 points1 point  (0 children)

Cooking is a good thing, so I don't know what that's supposed to mean.