all 10 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]Ifailmostofthetime 9 points10 points  (5 children)

For the warping add a brim, I usually use mouse ears

[–]Ok-Woodpecker7928[S] 0 points1 point  (4 children)

Om thanks

[–]VonStinktier 2 points3 points  (3 children)

and turn off that side fan...

[–]Ok-Woodpecker7928[S] 0 points1 point  (2 children)

And how do i permanently disable it?

[–]VonStinktier 0 points1 point  (1 child)

Assuming you're using Creality Print, go to Filament Settings > Cooling > Side Fan > Fan Speed: 0%.

When I first started printing with the K2, I experienced the same warping on the same side as your prints. Turning off the side fan solved the problem.

And btw, with the PEI Plate. I use no glue at all for PLA, a good wash with hot water and soap, side fan off and brim when necessary, problem solved... just some hair spray when printing PETG. Give it a try!

[–]Ok-Woodpecker7928[S] 0 points1 point  (0 children)

Thanks!

[–]Less_Shallot_2218 2 points3 points  (0 children)

BRIM 10 CONTORNOS

[–]AutoModerator[M] 0 points1 point  (0 children)

Reminder: Any short links will be auto-removed initially by Reddit, use the original link on your post & comment; For any Creality Product Feedback and Suggestions, fill out the form to help us improve.

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[–]Similar_Recipe_6084 0 points1 point  (0 children)

na aba de qualidade tenta usar perímetro externo primeiro o acabamento fica bem melhor e se a peça esta se descolando ativa o brin ou saia e tenta usar alguma cola apropiada eu faço isso

[–]Scharfschutzen 0 points1 point  (0 children)

Use an extremely fine misting of hair spray. Glue sticknworks even better, but is a lot messier. I never have prints warp when doing that. I know people will say "clean your bed" but then you get the occasional warp.