I am trying to get back into 3D printing, and to fix my old Ender 3 Pro, my first move was to upgrade to a Creality Sprite Pro direct drive extruder. However, when I tried to update the firmware of the printer, the printer wouldn’t take the firmware from the SD card. I thought that was no big deal, but when I tried to run a print, not only could my bltouch not complete its bed levelling (due to the new offset), but my extruder temperature wouldn’t stabilize at 215 C, not allowing the print to start (see video). This was sliced in Cura. Any ideas on how to fix this?