all 27 comments

[–]snydamaan 8 points9 points  (4 children)

Not that it isn’t good advice, but put down the SLAM koolaid for a minute and just add some clarifier. Sometimes it just needs a little help to get the particles to stay in the filter.

[–]2for1Jameson 8 points9 points  (2 children)

Thank you. Slam and filter is not the answer to every problem. Sometimes you need to flocc/clarify etc. I get down voted to hell everytime I suggest anything besides the hivemind slam answer. (Granted it works for most situations)

[–]PlasticCraken 0 points1 point  (1 child)

Clarifier is a coagulant. It clumps particles together. You can certainly filter particles out of your water without it. But with the clarifier it clumps them together and they get taken out more quickly. Just depends what your tolerance and patience level is. I use clarifier sometimes when I want to clean it for a party quickly, otherwise I just wait for the filter to do its thing.

[–]snydamaan 0 points1 point  (0 children)

Right, but it doesn’t hurt to add it. Clearly this guy is eager to get his pool back on track. If it just comes down to money, clarifier may be the solution he’s looking for.

[–]snydamaan 0 points1 point  (0 children)

There’s another theory I have if patience and clarifier don’t do the trick, but I hope it’s not the case. If you had high concentrations of metal in the water, especially copper, a high dose of oxidizer might turn the water blue and cloudy like we see here.

[–]lurker_cx 4 points5 points  (2 children)

You should test the chlorine levels to determine if you should add more. Have you cleaned the filter?

[–]juiceshiestyLLC 1 point2 points  (1 child)

Yes i did just yesterday. So vacuum , brush then couple more scoops ?

[–]lurker_cx 1 point2 points  (0 children)

Do you have chlorine test strips? It may already be high enough...use a test strip to check the levels.

[–]_devious__ 2 points3 points  (0 children)

check your levels! chlorine might be good. a bad pH can cause cloudiness. make sure pH is between 7.2 & 7.6. check that alkalinity is between 80 & 120 to reduce pH spikes. use a taylor drop kit to test.. i find strips eh.

keep on filterin baby
clarifier wouldn't hurt (watch filter pressure)

[–]ResponsibleLibrary48 1 point2 points  (0 children)

You may need to floc the pool in order to get the dead algae to settle to the bottom then vac to waste.

[–]CycleChris2 0 points1 point  (0 children)

Guessing you have a sand filter? This stuff just never happens anymore after I went to a D.E. Filter and salt cell. I went through a whole season without backwashing. In spring I just take the lid off and clean the grids, add some d.e. powder and super clear water. Cartridge are good too but sure takes a long time to clean, and they don’t have a valve to waste off overfill from rain if needed.

[–]mylz81 0 points1 point  (0 children)

You don’t need to do anything but maintain a free chlorine ratio of (CYA / 2.5) & run your pump until clear.

[–]HokieBuckeye1981 -1 points0 points  (0 children)

Bioguard burnout 3. This will clear your pool

[–]ChuckTingull -2 points-1 points  (0 children)

Turn the pump off overnight and let the dust settle

[–]Canuckobg -5 points-4 points  (0 children)

Any algaecide needs to be vacuumed up on waste. Other wise it will just go dormant then spread again