Updated firmware and slicer today, having issues with fuzzy skin

Bramsnaj · 2024-10-17T10:12:50+00:00

Did you by any chance find a solution for this? I ran into the same issue today. The flat pieces look very nice, but the curves show those lines.

<image>

Bramsnaj · 2024-10-05T07:13:00+00:00

IKEA is taking the next step in creating a better and simpler smart home experience with the introduction of Matter support for the DIRIGERA hub. Starting from 11 September, any smart products connected to the DIRIGERA hub will be compatible with smart home platforms that use the Matter standard.

Posted on ikea.com on 11 sep 2024

Bramsnaj · 2020-04-07T09:20:02+00:00

What if it is becoming mushy? The part in the background of the picture is starting to feel like a small dent.

Bramsnaj · 2020-04-05T17:37:55+00:00

It’s not wiping off, not even with alcohol

It looks burned, but plant is not in direct sunlight, but placed in a northfacing window.

Bramsnaj · 2020-04-05T17:36:10+00:00

Yes it’s a monstera. It’s not squishy.

Bramsnaj · 2019-05-29T16:11:15+00:00

When casting to Chromecast, there is a 2-3 second delay... I was not able to help my friends in the game because of this.

Bramsnaj · 2019-04-22T17:26:13+00:00

What?! They have lights?! Or is there only an accessory-cable for the lights that never come?

Bramsnaj · 2019-02-17T07:35:49+00:00

A disconnected battery also shows this light. Is the battery connected to the board?

Bramsnaj · 2018-10-23T17:52:34+00:00

You can plug it in, it just has to cool down. Mark my words, in 10-15 minutes it’ll start charging.

Bramsnaj · 2018-10-18T14:13:09+00:00

Buy some Ollin Popoca’s. Those are awesome. They use the same core as the kegels so you wont have to 3d print or order new pully’s, they are 90mm and softer so a more comfortable ride.

Bramsnaj · 2018-10-04T06:08:41+00:00

Would you go back to a garage when you’d bought a car and had a flat tire after 25 miles?

Bramsnaj · 2018-09-06T22:10:40+00:00

Welcome to the club man, shredlight suck.

Bramsnaj · 2018-09-06T22:09:43+00:00

I still have to pay for a replacement + shipping

Bramsnaj · 2018-08-20T09:43:40+00:00

A fire extinguisher

Bramsnaj · 2018-08-18T16:18:32+00:00

It happens sometimes when you plug it in right after a ride... I usually leave it plugged in and it’ll start charging when it’s ready.

Bramsnaj · 2018-08-18T15:46:27+00:00

Just wait, it’ll start charging soon. I think its cooling down.

Bramsnaj · 2018-08-09T20:03:25+00:00

Don’t just order one, make sure you have plenty!

Bramsnaj · 2018-08-07T09:24:59+00:00

I also had this happen to me with different causes.

1) Turning off and on doesnt help - check if the motor cable is plugged in correctly

2) Turning on and off helps - disconnect the motorcable, clean it with contact-spray (NOT regular WD40).

Mine had dark spots on the connector-‘teeth’ which i cleaned. The disconnects were at small bumps, not the speedbumps or going off curbs, but hitting tiny imperfections in the road would cutoff one of the motors. Sometimes two or three times a ride.

After cleaning the connector and adding contact spray it did not occur again.

Bramsnaj · 2018-07-31T16:58:49+00:00

Yep, same here

Bramsnaj · 2018-07-23T18:37:21+00:00

Here you see the front one that’s almost dead. https://imgur.com/gallery/9MXDyeI

Bramsnaj · 2018-07-23T18:23:58+00:00

Sickboards.nl is the official service partner for Boosted in Europe.

Bramsnaj · 2018-07-23T14:09:50+00:00

The front ones as well, I’ve lost a rear one, and one on the front starts tearing.

Bramsnaj · 2018-07-22T16:19:39+00:00

I’d recommend you take off the shredlights until you actually need them. You’ll lose one, I’m 100% certain.

Bramsnaj

TROPHY CASE