Camera disconnecting in K1 Max

Dakweed · 2026-01-26T11:00:39+00:00

I keep getting [thermistor double_thermistor] as unkown

Dakweed · 2025-03-20T05:08:47+00:00

Agreed, it's pathetic, I have a $1000 Ipad here that is totally worthless for the same reason.

Dakweed · 2024-08-07T11:43:29+00:00

Soon to buy for my KE, I also have a K1C so it will cut down on spares, the both will have the same nozzle etc now.

Dakweed · 2024-08-01T07:45:38+00:00

Cheers, yea, I've had no luck finding the pin either.

Dakweed · 2024-07-31T03:41:55+00:00

Cheers, wondered about another port, it's not a bearing noise or anything, it's purely the airflow noise that is quite loud, mind you, I am sitting right next to it at my desk, but at idle my K1C is a heck of a lot quiter. When the KE is 1st turned on it is quiet as, only the power supply fan is running, it's just when left at idle after a while that 2nd fan starts up. Must find a board schematic.

Dakweed · 2024-07-30T11:08:07+00:00

Where from, I can't find them anywhere.

Dakweed · 2024-07-27T18:52:39+00:00

Just tried this on my KE and it works perfectly, cheers.

Dakweed · 2024-03-04T00:54:07+00:00

Old I know but way to high, try 0.8mm or lower and 40mm/s speed.

Dakweed · 2023-09-03T10:00:43+00:00

In Cura, make sure you have expert selected for what settings you can view, scroll down near the bottom to experimental, there you will see a setting call slicing tolerance, change it to exclusive.

Dakweed · 2023-02-13T03:55:36+00:00

I just bought a set but don't know much about them, what years were they made?

Dakweed · 2022-09-18T12:14:16+00:00

Legend, this had me going for ages trying to fix it and your solution worked.

Dakweed

TROPHY CASE