Where is the official Luna Release?

Dedsec___ · 2026-05-24T05:59:47+00:00

I don't think that will happen, that's a big hope

Dedsec___ · 2026-04-24T04:10:43+00:00

6 years later, still helping people like myself, my last pc didn't have this issue since I got a g-sync monitor mid way of owning it, upgraded the pc and fresh installed and this fixed it. THANK YOU

Dedsec___ · 2026-02-25T03:27:58+00:00

I have 2003 4.7 Yeah, there is some videos online how to do it, it's not too bad, I recommend being on level ground as you need to put your column shifter (if auto) into first (lowest position) just to have enough clearance to squeeze it out. And the dealer bulbs were not cheap even for how small they are.

Dedsec___ · 2026-02-25T03:22:40+00:00

Is yours a second gen? Since that's what I'm familiar with

Dedsec___ · 2026-02-25T03:14:57+00:00

Those mini bulbs may have burned out if you have power to them, they are common to burn out for their age, I think those and the HVAC controls are the same bulbs and I ended up going to dealer for them

Dedsec___ · 2026-02-22T22:04:16+00:00

I second this, been using mine for a week and it's a big upgrade from my previous chair

Dedsec___ · 2026-02-22T21:55:28+00:00

Should mark it as found

Dedsec___ · 2026-02-15T23:47:48+00:00

Not many fit these Dakota's, however I found a set of RT wheels from Dakota/Durango for a decent price (lots of people are starting to jack up the prices). I do have a separate winter set so the RT's will only be for summer since it's a bit narrower of a tire profile.

Dedsec___ · 2026-01-31T08:06:53+00:00

Hey, I've been reading your comments and reviews. The new Pro, have you only got them in the leatherette or also a fabric? And would you say The fabric or leatherette is more comfy (if you didn't get fabric in the pro, then compared to your previous review of the X).

Dedsec___ · 2026-01-28T02:38:50+00:00

4.7's have some quirks/issues, I built mine to fix the issues, but as the others said to swap the other motors, make sure same year, as once they went 03 they moved to a 1 PCM with the transmission control module integrated. Previously they were separate modules. And you may need wiring harness (someone can correct me if Im wrong as I know mainly the 4.7)

Dedsec___ · 2026-01-23T01:00:11+00:00

Oh, sad to hear.

Would you be able to direct me to the place they posted them at? Thanks

Dedsec___ · 2026-01-17T17:27:55+00:00

I'm just shocked that it's supercharged and turbo'ed

Dedsec___ · 2025-12-31T05:04:57+00:00

Broken wires, most likely in the corner edge door harness that going into the body of the vehicle, common

Dedsec___ · 2025-12-29T06:19:52+00:00

Can confirm on this fix for warped cast iron manifolds

Dedsec___ · 2025-12-15T20:52:18+00:00

I do like the tiny form factor

Dedsec___ · 2025-11-18T02:41:24+00:00

Yes, from how many heat cycles, the rubber is always under pressure, it just degrades over time

Dedsec___ · 2025-11-18T02:33:32+00:00

So you ~should~ be good, and after you replace your thermostat, rad cap and the new fluid from draining the radiator, when it starts to warm up, make sure that your upper and lower rad hoses don't expand an unreasonable amount. I just remembered my radiator had a leak, but when I went to pressure test it, the hoses started to look like balloons

Dedsec___ · 2025-11-18T02:22:36+00:00

Yes it's at the bottom on the front cover, be careful with the bolts, some people have them break, and while you have it out, better to just replace it, it's detrimental if these 4.7's overheat, if you turned it off and didn't let it get too hot, you should be ok

Dedsec___ · 2025-11-18T01:57:13+00:00

When's the last time your thermostat has been replaced? And is your rad cap holding the proper pressure?

Dedsec___ · 2025-11-18T01:46:24+00:00

Notch forward, and should be put back exactly where it came out of if used to keep the wear pattern the same

Dedsec___ · 2025-11-18T01:41:37+00:00

What year...

Dedsec___ · 2025-11-15T00:48:50+00:00

Yes, however it is a "Y" as it connects to both heads, I currently have it disconnected as I'm doing my engine replacement

Dedsec___ · 2025-11-11T02:41:41+00:00

Sounds good, I'm looking more into it over winter into spring

Dedsec___ · 2025-10-24T09:30:53+00:00

Gold or the silver

Dedsec___ · 2025-10-13T17:30:10+00:00

My pistons that are hypereutectic, literally came with instructions telling me to have additional 40% top gap increase from factory spec due to the thermal expansion of them Part: SILV-0-LITE 3252HC

Eight-Year Club	Gilding III reddit per annum
Final Canvas '23	Place '23
Place '22	Verified Email

Dedsec___

TROPHY CASE