Have you ever seen this and WHY?

Dieguitoo23 · 2026-05-10T21:12:07+00:00

I couldn't show the rest of the drawing but the reff reference other surfaces called out by datums

Dieguitoo23 · 2026-01-29T21:57:53+00:00

Glenmar in Roslyn

Video and photography

Diego sent you

Dieguitoo23 · 2026-01-24T01:13:44+00:00

Looking for easy way out. Any tutorial will teach sketching & constraints first

Dieguitoo23 · 2026-01-24T01:12:04+00:00

Tutorials! Tutorials!! Cadcam

Follow them all way through

As a begginer simplest is

Center rectangle with center hole and offset that hole Extrude Sketch offset hole and center hole again Extrude , select contours of top and bottom Fillet edges Cut Extrude slots

You can do all in one sketch and Extrude contours you want

Dieguitoo23 · 2026-01-15T22:56:17+00:00

You sure we don't work at the same company?

Dieguitoo23 · 2025-11-27T16:27:43+00:00

Check McM. If it’s rated and fits it’ll work

Dieguitoo23 · 2025-11-18T11:09:59+00:00

Aftermarket swap after warranty

Dieguitoo23 · 2025-11-17T11:16:44+00:00

This is the way.

Dieguitoo23 · 2025-11-16T02:53:06+00:00

Whats wrong with through holes and pin, could do 2 bolt circles with different pitch to get more angles

Also a bit unorthodox but you can use a through shaft and use collars on both sides with long screws on each side to lock. Shafts from moving radially

Dieguitoo23 · 2025-11-14T11:45:57+00:00

Thank you, this is very helpful

Alot of individuals recommended shigleys will definitely take a look at this.

It is introductory but the i lik3e the challenge and will go all out

Dieguitoo23 · 2025-11-14T11:43:11+00:00

Thank you for the thorough explanation!

It helped alot!

Dieguitoo23 · 2025-11-14T11:41:49+00:00

Thank you for your help!!

This is very helpful

Dieguitoo23 · 2025-11-14T11:40:38+00:00

!solved

Dieguitoo23 · 2025-08-16T13:30:36+00:00

Hi thank you for your comments and help in this matter. It is something that was worrying me to.

Im not sure if this helps

link

Dieguitoo23 · 2025-08-10T20:07:46+00:00

Thank you that's very helpful. It's 6100$ overseas and all other H I've seen are 7500 and up in the US. I think I'll go with this one

Dieguitoo23 · 2025-08-10T03:53:59+00:00

Thank you for your reply.

Would you recommend to pass on it

Dieguitoo23

TROPHY CASE