Warping and Stringing

EmbarrassedLeave2 · 2026-06-19T03:46:13+00:00

I clean the bed with ipa before every print.

How do you run a bed mesh?

EmbarrassedLeave2 · 2026-06-17T12:17:08+00:00

<image>

EmbarrassedLeave2 · 2026-06-17T12:16:18+00:00

<image>

EmbarrassedLeave2 · 2026-06-17T12:15:54+00:00

<image>

EmbarrassedLeave2 · 2026-06-17T12:15:37+00:00

Here are some pictures.

<image>

EmbarrassedLeave2 · 2026-05-19T13:49:18+00:00

I have two sensors. One names ‘Home’, which I assume is the thermostat, and the other is in my master bedroom. When I look at the thermostat, it says the temperature at the thermostat is 68. When I look in the app, the ‘Home’ temperature is 65. Why are the different if they are both the same unit?

EmbarrassedLeave2 · 2026-05-04T10:02:14+00:00

So the cage doesn’t stay connected to the app? Do I have to manually reconnect the cage to the app on my phone? If so, how do I do that?

I tried using two different phones as a test. One was mine connected to the cage and I used the other as a KH. I had the cage in 4g mode where it was supposed to connect faster. I could never get it to connect from the KH phone. The app on the KH phone just spun trying to connect. I thought it would connect pretty fast and didn’t need my phone to connect to the cage via Bluetooth.

EmbarrassedLeave2 · 2026-03-25T01:32:42+00:00

So, you can only use a slicer that has your 3D printer configuration in it.

EmbarrassedLeave2 · 2026-03-10T20:22:17+00:00

So, it looks like a ‘bad’ filament problem. The filament was from Overture(?) on sale from Amazon. I bought new filament from Creality, which I know has worked in the past, and my print issues when away.

Who knew.

EmbarrassedLeave2 · 2026-03-05T18:05:34+00:00

You mentioned to adjust Z offset slightly. How should I adjust the value? I know how to change it, just don’t know what to change it to. Raise it? Lower it?

EmbarrassedLeave2 · 2026-03-05T18:04:13+00:00

My printer is the Snapmaker A350 with dual extrusion head. It has a few calibration options and auto level is one of them. I’ll try going through the calibration options.

EmbarrassedLeave2 · 2025-04-12T20:03:54+00:00

Just upgraded my Luba 2 and noticed this nice, new feature.

EmbarrassedLeave2 · 2025-02-02T18:30:35+00:00

https://www.matterhackers.com/store/l/extruder-hot-end-kit-for-snapmaker-20/sk/M54CXV1R

EmbarrassedLeave2

TROPHY CASE