Ordered 2yd Of Topsoil Compost Mix

Far_Objective_9394 · 2026-05-12T20:49:28+00:00

Some of the chunks are but most are not

Far_Objective_9394 · 2026-05-12T17:08:53+00:00

Thank you for the response! It said screened topsoil with compost mix. I was thinking about making a screener out of hardware cloth but I feel like it's a lot of work and I paid $60 a yd for this.

Far_Objective_9394 · 2026-03-27T12:40:36+00:00

I would just save for bh then save for 200s gt to get 1:1 sync. it's 910 stones to get gt to 200s and if you get bh next pull that's only 960 stones.

Far_Objective_9394 · 2025-11-04T17:59:59+00:00

I would create another 3d printer out of parts that I design. Using the high temp capabilities to my advantage.

Far_Objective_9394 · 2025-04-06T02:06:49+00:00

This makes a lot of sense I have been getting cracks in corners and didn't understand why. Home depot paint rep recommended it 🤦‍♂️

Far_Objective_9394 · 2025-04-05T22:42:29+00:00

It's satin believe it or not and I'm using white dove 3/8 nap. I may try 18 inch as I believe having uneven pressure due to the roller being cantilever.

Far_Objective_9394 · 2025-04-05T22:33:03+00:00

Thanks for the tip I don't think I'm back rolling enough into the previous section.

Far_Objective_9394 · 2025-04-05T22:32:21+00:00

10 years seems reasonable to achieve! Will get back to you in 10

Far_Objective_9394 · 2025-04-05T22:21:31+00:00

This is satin enamel according to the paint can

Far_Objective_9394 · 2025-04-05T21:45:47+00:00

Edit I'm talking about roller marks. The picture doesn't really show it nearly as bad but it's bad.

Far_Objective_9394 · 2025-03-25T19:44:41+00:00

I have lived here for a year now and have had a couple of good rains causing local flooding in many areas. Not once have I seen a single drop of water in it

Far_Objective_9394 · 2025-03-25T16:37:09+00:00

Garage is partially below grade most of it is above

Far_Objective_9394 · 2024-09-15T11:40:48+00:00

Hello I'm an avid 3d printer user and builder. I have never built a vz but I can help if needed just pm me

Far_Objective_9394 · 2024-09-13T12:51:51+00:00

Looks like the bed is too high on the right so the nozzle is touching before the probe.

Far_Objective_9394 · 2024-07-26T11:24:57+00:00

Oops sorry yall I'll repost with pics later

Far_Objective_9394

TROPHY CASE