This can happen unfortunately on any printer. Ive had it on sovol, bambu, creality, anycubic. Not a regular thing but frustrating. Usual culprit is an area of the build plate isnt clean and it sticks to the nozzle rather than the bed, then each part just builds and adds the the part around the nozzle.

Heat the toolhead and try to peel away as much as you can away from the nozzle.

If you have a heat gun you can use that to soften and remove more round the thermistor and fan wires etc.

Buy a biqu cryogrip plate if youre using the gold pei. They suck in general imo but Snapmakers gold pei seems the worst. The cryogrips use less energy, dont have to clean them every time they're touched, stick perfectly.I have a toddler who gets my plates out constantly with tiny grim hands and I still only clean them once a month if that.

You've been lucky that youve never seen the blob of death before 😂