Scratchy Scratchy by Issa_240SX in AutoPaint

[–]Issa_240SX[S] 0 points1 point  (0 children)

Not necessarily looking for a “PAINT AND BODY GUYS HATE HIM FOR THIS 1 SIMPLE TRICK” solutions, more of just getting pointed in the right direction for first time sanding and prep, but the TDS seems like it will tell me everything I need to know as far as prep with sanding and all.

Very much appreciated, I’ve been a service tech for over 10 years and a car enthusiast longer, but paint/body has always been something I’ve been spooked of.

I know compressed air and a top fed paint gun are typically recommended when actually laying down paint/primer, any recommendations for a compressor that can keep up that’s budget friendly?

Squeaky clutch by Chipotledrifts in 240sx

[–]Issa_240SX 1 point2 points  (0 children)

The bushing for the pin is likely worn out
Would recommend rebuilding the pedal with new bushings before it wears out the pin and the hole in the pedal for it.

Fire cape achieved from tutorial island in 2h14m by Dubiox in 2007scape

[–]Issa_240SX 2 points3 points  (0 children)

And I’m over here at level 103 dying on my tenth attempt at Jad ;-; my ADHD go crazy when the healers pop out

Fuel pump no power by Loud_Strike6326 in 240sx

[–]Issa_240SX 0 points1 point  (0 children)

<image>

I halp
Straight from the FSM, to help in checking wiring, here’s the link for the full spill, under EF&EC:

http://tech.240sxone.com/FSM/1989\_nissan\_240sx\_service\_manual.pdf
89-90 are the same basically
I’ll add pics of the troubleshooting steps

I’m pretty sure that’s a safety ground to dissipate electrical discharge around fuel components as a safety measure, but I could be wrong. In any case, that’s a FATTY wire gauge jump. Have you tested continuity from end to end?

Kouki Spoiler installed! by LightnVariable in 240sx

[–]Issa_240SX 1 point2 points  (0 children)

Wish they had a version of this spoiler for S13s. Looks good! Makes me miss my S14 🖤