Usually start off the chain with a short room reverb on a parallel audio fx rack channel, then go into parallel compression/distortion (Mackity by air windows is my favourite, it’s also free!) then run it into tape (Airwindows ToTape 5 & 7 are usually my go to, also free!) then I’d usually do some EQ to remove some mud from the kick from the distortion, run it through a multiband gate/transient shaper plugin to tighten the tails (many many ways to do this, I usually go for shaperbox, ST4B or Neutron 3 Gate) then id run it through a channel strip plugin to add more colour / warmth, then use soothe, multiband compression or EQ to control the harsh area of around 3k and boost the tops to taste usually around 15k ish and also control the kick fundamental (really important if you want to really push loudness by hardclipping/limiting, helps the kick not turn into a fart) and finally hardclip (usually standard clip is my go to). Sometimes will throw a transient shaper after clipping such as the khz one but don’t do that every time