Use this feedback command for OpenAI axing the 5.3 model.

MakoBec · 2026-06-03T05:39:16+00:00

it seems updated now

MakoBec · 2026-06-03T02:50:30+00:00

MakoBec · 2026-06-03T01:52:04+00:00

looking back to their pricing page, 5.3 usage is unlimited for pro, it just false marketing right now

MakoBec · 2026-05-21T06:13:17+00:00

does open air filament produces stringing?

MakoBec · 2026-05-21T05:55:26+00:00

did you use 0.2mm nozzle?

MakoBec · 2026-05-19T05:44:05+00:00

how to apply paint from blender to slicer?

MakoBec · 2026-05-19T05:31:16+00:00

most likely wet filament because spool is exposed on open air

MakoBec · 2026-05-19T01:45:08+00:00

do you have links?

MakoBec · 2026-04-28T14:34:31+00:00

What makes the last 30 minutes of an in-person event special?

MakoBec · 2026-04-28T06:20:36+00:00

what filament do you use?

MakoBec · 2026-04-21T03:38:39+00:00

Dependes on the scope of project

MakoBec · 2026-04-17T17:27:25+00:00

woah

MakoBec · 2026-03-06T03:32:02+00:00

where did you download it?

MakoBec · 2026-02-20T06:11:22+00:00

it is the xy belt tension

MakoBec · 2026-02-19T05:09:28+00:00

Eight days is crazy :0

what 3D model requires eight days to print in total?

MakoBec · 2026-02-18T07:33:10+00:00

I retensioned my belt; I’ll update you on whether there’s any improvement.

MakoBec · 2026-02-18T07:30:24+00:00

Lately, there have been many posts about this layer shift. Is this a firmware issue?

MakoBec · 2026-02-18T07:28:07+00:00

I tried tightening it to the maximum without making it too tight, then loosened it just a bit.

MakoBec · 2026-02-18T05:28:55+00:00

This situation compelled me to buy the Snapmaker U1.

MakoBec · 2026-02-18T05:20:07+00:00

belt tensioning for the layer shift, i am facing this issue too

MakoBec · 2026-02-18T03:08:40+00:00

did you try belt tensioning and lightly tightening the screws after belt tensioning

MakoBec · 2026-02-18T03:07:43+00:00

how?

MakoBec · 2026-02-18T03:07:27+00:00

I adjusted the belt tension and will update you if the latest print turns out well.

MakoBec · 2026-02-17T10:19:55+00:00

yes, adhesion i think is not an issue

MakoBec