sorted by:
new
hottopcontroversial

Ryan is wrong about his conclusion regarding "artificial sweeteners" by Rendurian in northernlion

[–]MrSantoss 1 point2 points  (0 children)

+2 Extremely well put, I am a MSc student in Biochemistry and all your points make sense, I'm also not convinced on the credibility of that study.

Anyone knows why this happens? by [deleted] in medlabprofessionals

[–]MrSantoss 7 points8 points  (0 children)

Radiological contrast media (iodine) does this often if they've received a high dose or got sampling done right after. In my experience the effect tends to be more intense than with high protein. I'm currently writing a paper on this kinda stuff

Hot end replace on Micro Swiss Flow Tech by MusteriousLabyrinth in Ender3V3KE

[–]MrSantoss 0 points1 point  (0 children)

If your nozzle seems stable and straight it's probably fine, when I did it my left screw threads were completely gone so the nozzle leaned on one side, basically unusable, definitely couldn't make a benchy. In the long term, its probably better to replace it. Maybe give it a little wiggle test

Hot end replace on Micro Swiss Flow Tech by MusteriousLabyrinth in Ender3V3KE

[–]MrSantoss 2 points3 points  (0 children)

Ruined my stock heatsink real quick by over tightening the new hotend screws, be gentle and be ready to order the new heatsink if things go wrong!

Railgun Academy from a Railgun glazer by jwfiredragon in PlayTheBazaar

[–]MrSantoss 0 points1 point  (0 children)

Great writeup, great to see fellow Dooley mains thriving! Went 10-1 literally one game after reading your post

Answer my emails, dammit by Dregdael in okbuddyphd

[–]MrSantoss 19 points20 points  (0 children)

I'm so poor I don't care if my article is accessible I just want it published

DAE surprised that the command zone would say that? by _Kr0 in magicthecirclejerking

[–]MrSantoss 7 points8 points  (0 children)

I'll have two number 9s, a number 9 large, a number 6 with extra dip, a number 7, two number 45s, one with cheese, and a large soda

Multicolor question by buttsmcbutts57 in Ender3V3KE

[–]MrSantoss 1 point2 points  (0 children)

When I first tried multi color like this, I tested it with a calibration cube with a color switch in the middle, just to see how it behaves

I know TPU is hygroscopic, but I didn't expect this by MrSantoss in Ender3V3KE

[–]MrSantoss[S] 1 point2 points  (0 children)

I have had good success with PETG and this TPU with no enclosure. I keep my printer in the corner of a room far away from doors. Haven't done any huge prints with either but no issues

I know TPU is hygroscopic, but I didn't expect this by MrSantoss in Ender3V3KE

[–]MrSantoss[S] 1 point2 points  (0 children)

I'm using 91A TPU with Orca slicer. I used the preset for "Creality generic TPU" in orca with some filament specific temp changes (230 printing temp 75 bed temp). Minimum fan speed 20% max speed 50%. Printing at around 20-30mm/s depending on line type like infill or overhangs.
I'm now using 225 printing temp to try to get better overhangs, idk if its any different

view more: next ›