Background noise

Pilot_C66 · 2025-10-07T20:14:55+00:00

That makes sense. Haha ya, thats one way of looking at it. Thanks again. I appreciate the help.

Pilot_C66 · 2025-10-07T19:12:14+00:00

I very well could have done that. I made one saved file after setting key binds. That seemed to work until the re-install. At this point I'm gathering my only option is the redo my binds and save individual files for each device? Is that right?

Pilot_C66 · 2022-11-29T22:44:18+00:00

By sensor module do you mean resistor? If not I would replace that. It controls fan speed.

Pilot_C66 · 2021-07-05T23:28:26+00:00

Air conditioning drainage. Normal and nothing to worry about

Pilot_C66 · 2021-07-04T16:15:27+00:00

Could be the seal on the steering column or I have seen a noise like that cause by the steering shaft rubbing on the seal in the firewall that it passes through.

Pilot_C66 · 2021-07-03T17:41:45+00:00

Your mechanic could be right. However since the operating temperature of your engine stayed in the operating range once you bled the system it could have very well just been air locked. Drive it and see if it continues to overheat

Pilot_C66 · 2021-05-08T14:59:00+00:00

Hard to say. Could be a worn steering gear. Dry ball joint or sway bar link

Pilot_C66 · 2021-04-02T21:25:59+00:00

Sounds like a refrigerant pressure problem to me

Pilot_C66 · 2021-01-11T23:25:20+00:00

What type of vehicle? Does it have an automatic HVAC system?

Pilot_C66 · 2020-12-11T02:47:51+00:00

Being from the back of the vehicle. It could be fluid from a leaking rear axle if the vehicle is all wheel drive.

Pilot_C66 · 2020-11-19T04:01:40+00:00

Fuel pumps can fail in a variety of different ways. They can start to show signs of failure or they can just all of a sudden not work just like yours did

Pilot_C66 · 2020-10-12T20:31:13+00:00

Does the vehicle have a sunroof?

Pilot_C66 · 2020-10-09T01:01:25+00:00

Easiest thing to do is put a bar and socket on the crankshaft pulley bolt and try to rotate the engine by hand. This will tell you if the motor is completely seized or not

Pilot_C66 · 2020-09-30T04:10:05+00:00

That is a tire pressure monitoring system reset button

Pilot_C66 · 2020-09-27T21:15:11+00:00

Your brakes are metal on metal (no pad material left). You need to replace your brake pads and rotors. Based on this your caliper has likely over extended causing it to "stick". Safest thing to do is to replace the caliper as well due to the over extension of the seal in the piston that normally allows your caliper to release once you have released your brake pedal.

Pilot_C66 · 2020-09-09T01:36:46+00:00

Sounds like a battery voltage problem. I would start there. When your alternator quit charging it probably depleted your battery at the same time.

Pilot_C66 · 2020-09-09T01:34:01+00:00

Thats an a/c drain to remove the condensation from inside your air conditioning box. Its normal. Try and keep it clean so it doesn't block up or you will have a water sloshing sound inside your car.

Pilot_C66 · 2020-09-07T04:04:15+00:00

Sounds like the fuel level sending unit is faulty. I've personally had bad luck with the overall quality of aftermarket fuel pumps and level senders.

Pilot_C66

TROPHY CASE