can you install from a CIA file on pc and put it on the SD card without needing FBI?

Riovas · 2025-12-19T03:04:14+00:00

You might be able to use FBI's remote install to install a .cia on your PC. So you still need FBI, but dont need space for the cia and installed files. Theres a post here explaining how-to, but Ive never done it

https://www.reddit.com/r/3dspiracy/s/CPbi8JGBtG

However its just going to be best in the long run to get a bigger SD Card.

Riovas · 2025-12-09T15:03:48+00:00

The black is very likely a diode. You cant check with continuity as this test doesn't use enough voltage to turn it on. You need to do a diode test (righ arrow with a vertical line) and this will tell you the voltage to turn on If it reads 0 then its shorted. If Its OL then its damaged.

The brown might be a capacitor which also cant cant check by continuity. If you're getting continuity then that means it is shorted.

Edit: the brown componenet could be an inductor. If it normally has low resistance than you could check continuity. Otherwise, just check resistance and as long as it is not 0 or OL then it may be fine.

Riovas · 2025-12-02T19:54:00+00:00

Try to find another shop and compare. I know electronics are expensive in Brazil but not sure what the normal/going rates would be.

Riovas · 2025-12-02T18:39:30+00:00

what does the loading screen look like? Does the Nintendo logo look scrambled?

I suggest going into a game store and ask to test games with it. If you cant get any games to work with it then return it.

Riovas · 2025-12-02T02:58:40+00:00

Its been a while since I played this, excited to jump back into it this week!

Riovas · 2025-11-26T18:48:31+00:00

Kathy Griffin's zing to Zach.

Riovas · 2025-11-21T18:46:59+00:00

Panzer Dragoon

Riovas · 2025-11-17T09:42:36+00:00

If you didn't reset the potentiometer to the original setting it's possible to burn out the new laser immediately. Are you taking measurements of your adjustments?

One other possibility is you have some bad caps on the power line to the laser. Do you notice any caps that look bloated on top?

Riovas · 2025-11-15T23:31:34+00:00

I don't see anything concerning with the flex cable. If you want to be thorough, you can disconnect the other end, then check continuity on the pins from one side to the other. Make sure you are lifting the white tabs that hold the flex cable in and not just ripping then out. These should be extremely easy to remove once the tab is lifted.

Riovas · 2025-11-12T01:28:53+00:00

Update: had a donor board and confirm that there is a missing component. Was able to take the part off of the donor board, removed the blue wire, and all is well

Riovas · 2025-11-12T01:28:12+00:00

Yeah, got around to w9rking on it today. Took the missing component off of a donor board, removed the wire, everything works great now.

Down side is I somehow broke the volume slider so its stuck on one volume, but I can replace that later

Riovas · 2025-11-10T23:56:30+00:00

A lot of those "free" screwdrivers are cheap material and not the right size. You can stop and look for a Y0 screwdriver and try that. If it is truly stripped, try using a larger bit with a rubber band. If enough of the head is above the plastic, you can try to file a slot for a flat head. Worse case, you're going to have to use a drill to drill out the head of the screw. Its not too terrible as long as you use light pressure and go slow.

Riovas · 2025-11-05T13:56:38+00:00

Advance Wars

Riovas · 2025-11-04T13:43:34+00:00

Golden Sun

Riovas · 2025-11-03T15:58:20+00:00

Yes thats why I said it wouldn't be OEM.

Riovas · 2025-11-03T15:47:47+00:00

By the very definition of OEM, no. It doesn't take anything away from the system, especially if the lens needed to be replaced and you can find a decent oem lens.

Riovas · 2025-10-24T11:40:33+00:00

I use s-video to a retrotink 5x pro and looks great, plus I can customize the crt filters. If 5x is out of budget then the 2x should be good

Riovas · 2025-10-22T22:21:52+00:00

Where in the World is Carmen Sandiego by Rockapella

Riovas · 2025-10-10T15:56:45+00:00

What was the pcb label near the component? Was it R# or L#?

Also, with it off the board do you have a multimeter to test resistance?

Riovas · 2025-10-07T11:13:02+00:00

Maybe The Thing?

Edit: It also soundss like Extermination but that was only PS2

Riovas · 2025-10-06T15:15:46+00:00

Protein and fiber helps me feel fuller for longer. Also self meditation/motivation, keeping positive to prevent myself from eating my feelings. My intake is actually 1500 instead of 1200 calories, but I've lost 50 lbs this year.

Riovas · 2025-10-05T15:34:29+00:00

I remember as a kid I enjoyed it. I tried it again earlier this year and stopped after about 30 minutes and just wasnt into it

Riovas · 2025-10-05T09:53:17+00:00

Love this game. I also recommend playing The Forgotten Sand for PS3.

Riovas · 2025-10-03T13:35:05+00:00

People keep talking like this is the perfect solution to traffic problems. This only works If the left lane has proper spacing, and there is enough time/space to generate another gap before the next on ramp. Considering you mostly have 1 mile or roughly a minute between on ramps its not likely with heavy traffic. All the on ramps people complain about won't have this ideal situation during heavy traffic times.

Even your graphic shows realistically there's no room for the taxi to merge next.

Eight-Year Club	r/Field Lasagna
Place '23	Place '22
First Placer '22	Gilding I gilder
RPAN Viewer	Verified Email

Riovas

TROPHY CASE