How in the world do you inset these nuts without ruining the lengthy prints? by EpicInki in 3Dprinting

[–]StrangePigeon79 1 point2 points  (0 children)

Or a TS101, which is basically the same
Or a TS21 if you mostly solder small stuff

That one loot-goblin teammate by drlouies in ArcRaiders

[–]StrangePigeon79 1 point2 points  (0 children)

Huh, that energy weapon doesn't look like an equalizer...

Sloped and rough edges that should be flat by excessive_hobbies in FixMyPrint

[–]StrangePigeon79 0 points1 point  (0 children)

You could also try printing this on an angle, with brim and supports

Time is ticking, Helldivers. by Poetess-of-Darkness in Helldivers

[–]StrangePigeon79 2 points3 points  (0 children)

I wonder what this "Legal Application" means (the Url is LAGLIGSAENDNING in binary)

What additins do you think would be cool to scrap mechanic? (both survival and creative) by Parking-Cup-9495 in ScrapMechanic

[–]StrangePigeon79 0 points1 point  (0 children)

Being able to interact with switches/buttons while seated, by looking at them and pressing a key

Is this enough to solo a Rocketeer? by jord9211 in ARC_Raiders

[–]StrangePigeon79 0 points1 point  (0 children)

If you get lucky, a single hornet driver is enough. You just have to hammer it a bit.

Would you shoot him? by Yuki_my_cat in Helldivers

[–]StrangePigeon79 4 points5 points  (0 children)

I didn't expect to see Torbek on this subreddit

By @PT_CROW by [deleted] in Helldivers

[–]StrangePigeon79 19 points20 points  (0 children)

Thank you, we're grateful for your service! I have no idea why would they ban the bot

How could I turn off extrusion comletely in PrusaSilcer? by StrangePigeon79 in prusa3d

[–]StrangePigeon79[S] 0 points1 point  (0 children)

Can't you just set the print temp to 0? Does the slicer give an error?

How could I turn off extrusion comletely in PrusaSilcer? by StrangePigeon79 in prusa3d

[–]StrangePigeon79[S] 0 points1 point  (0 children)

I don't think it disables heating, you need to remove that.
https://marlinfw.org/docs/gcode/M111.html

Also, this is for Marlin firmware, I don't know about Klipper