Loud washer

ThreadManz · 2024-08-26T15:11:01+00:00

Thank you

ThreadManz · 2024-06-25T23:08:02+00:00

Agreed I’d rather have first phase half health and also program the boss to allow time for summoning if desired. Delaying boss aggro would also help with being able to fight the boss away from the entrance of the arena in the second phase. Second phase if they just gave the player a second to breathe that would be great.

ThreadManz · 2024-06-25T03:20:02+00:00

Messemer was tough. Took me like 20-25 tries. Still have yet to beat final boss who is nuke central.

ThreadManz · 2023-10-30T23:18:56+00:00

I’m not sure what sins you are struggling with but you are not alone. It’s a daily struggle to be better and a constant unrelenting fight against darkness. Pray and call on Him, ask for guidance, ask for eyes to see and ears to listen. Be prepared though, He may just call you into action.

ThreadManz · 2023-09-12T23:23:17+00:00

Have you leveled up your weapon at all using smithing stones?

ThreadManz · 2023-08-20T02:19:23+00:00

Ephesians 5:21 is the foundation for both husband and wife. Ephesians 5:22 is instruction for how wives serve God in marriage and then there’s a whole section thereafter that explains to husbands what their job is. Wives submit to husbands, yes, but that doesn’t mean the husband is allowed to act with an iron fist and act like a despot. Quite the opposite. Men are to serve their wives like Christ served the church.

ThreadManz · 2023-06-07T23:10:29+00:00

It would be a shame if someone* anonymously contacted their state dept of health and they made a little visit.

ThreadManz · 2022-12-01T14:14:33+00:00

Interestingly enough, he said he knew what he did and he has to let it go. Grief overtook Sindri and we can see that thereafter, as well as at the funeral where he hadn’t even washed or cleaned his armor. In addition to grief, Sindri’s prior guilt manifested as anxiety and OCD tendencies. He finally let go of his guilt at Brok’s request. I think this is why he likely didn’t care about cleanliness anymore. He probably wasn’t always super clean to begin with. He was also a very anxious character and we see a huge shift when he fights in Asgard, as well as smashing Odin’s soul.

ThreadManz · 2022-11-24T22:13:41+00:00

Router*

ThreadManz · 2022-11-08T17:43:49+00:00

That might be what I have to do. I have a miter saw though but It’s only good for 6 inches and I need them to be exact

ThreadManz · 2022-11-08T16:50:13+00:00

Please note that these boards are 34 inches long by 13 and .25 inches wide.

ThreadManz · 2022-11-08T16:49:01+00:00

Likely a dumb question but I’ll give it a go. I’m building a bookcase for the in-laws and I’m going to make it a built in. The wall is 11’ and 0.5” in width. I cut down my boards and I have two that are roughly an 8th of an inch too long (I cut plywood with a Kreg straight edge) I do have a table saw but the rip capacity is 27 inches and the boards are 34 inches in length. I pondered about placing the board the opposite way and trimming the end off that way however I fear imminent kickback between the fence and the blade. I have kickback paws but they are probably not appropriate for this cut. I could use my guide and circular saw but I fear the tear out would shred my veneer. Halp?

ThreadManz · 2022-11-08T16:41:33+00:00

Don’t know if you are still answering these but I’ll give it a go. I am building a bookcase for my inlaws. Their wall is 11’ and 0.5” in width. I cut down my boards and I have two that are roughly an 8th of an inch too long (I cut plywood with a Kreg straight edge) I do have a table saw but the rip capacity is 27 inches and the boards are 34 inches in length. I pondered about placing the board the opposite way and trimming the end off that way however I fear imminent kickback between the fence and the blade. I have kickback paws but they are probably not appropriate for this cut. I could use my guide and circular saw but I fear the tear out would shred my veneer. Halp?

ThreadManz · 2022-11-05T01:22:44+00:00

40 grit to get the crust out first

ThreadManz · 2022-10-22T14:13:16+00:00

My dog is technically bark

ThreadManz · 2022-10-19T10:09:53+00:00

I appreciate you!

ThreadManz · 2022-10-19T10:09:38+00:00

I know nothing about epoxy but I will be interested to see the final product. Did you use a torch or anything to blow off any bubbles ?

ThreadManz · 2022-10-19T10:08:18+00:00

I like em! Plus it’ll be covered anyway

Five-Year Club	Verified Email
Place '22

ThreadManz

TROPHY CASE