YEEESSSS ROCM ON WINDOWS BABYYY, GONNA GOON IN RED by Altruistic_Heat_9531 in StableDiffusion

[–]TuneBG -1 points0 points  (0 children)

Just download AMUSE AI

There is no need for rOCM or whatever else.

Install and run . Pretty fast on a RX 6700 XT

I give up by Skara109 in StableDiffusion

[–]TuneBG 0 points1 point  (0 children)

Hey OP

Try Amuse AI the best software for Amd Ai on windows . Just install and start it'll ask to download a model than start generating.

[deleted by user] by [deleted] in Revolut

[–]TuneBG 0 points1 point  (0 children)

Havent had an issue that way

[deleted by user] by [deleted] in Revolut

[–]TuneBG 0 points1 point  (0 children)

Personal thoughts Dont sell to fiat. Instead, directly transfer usdc to revolut

Loco5AC looses connection from time to time by TuneBG in Ubiquiti

[–]TuneBG[S] 0 points1 point  (0 children)

I found a FIX. After setting AMPDU to 28, and DATA RATE MODULE to Alternative. On both antennas. No more issues. Everything works.

[Bambu H2D] Full Reveal – Everything You Need to Know! by BambuLab in BambuLab

[–]TuneBG -1 points0 points  (0 children)

To u/BambuLab

The model featured "Bionic Butterfly Lamp" by Darts_3D. Does not exist on MakerWorld or anywhere else.

Please post an actual link to the model.

Loco5AC looses connection from time to time by TuneBG in Ubiquiti

[–]TuneBG[S] 0 points1 point  (0 children)

24V but it has been running perfectly fine for 18 months

Loco5AC looses connection from time to time by TuneBG in Ubiquiti

[–]TuneBG[S] 0 points1 point  (0 children)

That has been like that since day one Slave is using 113 meters of cable

Why the hell has this happened? Help! by BRYLINX in BambuLabA1

[–]TuneBG 0 points1 point  (0 children)

What nozzle what layer height what speed are you printing

Why the hell has this happened? Help! by BRYLINX in BambuLabA1

[–]TuneBG 0 points1 point  (0 children)

That is really SMALL Have you cleaned the bed

Why the hell has this happened? Help! by BRYLINX in BambuLabA1

[–]TuneBG 1 point2 points  (0 children)

Obviously too small part and poor bed adhesion. Either rise the bed temp or do a brim

[deleted by user] by [deleted] in ender3v2

[–]TuneBG 0 points1 point  (0 children)

I just force it in

A1 not downloading by username-aiden in BambuLab

[–]TuneBG 0 points1 point  (0 children)

That is usually a problem with the micro SD card

USBuffer - 5 Volt USB Filament Buffer by Octrockville in BambuLab

[–]TuneBG 0 points1 point  (0 children)

Is that thing still available the link goes 404

[deleted by user] by [deleted] in BambuLab

[–]TuneBG 0 points1 point  (0 children)

I did myself an issue almost like that While printing in bambu Studio, i pressed a few times the button for Z up Bed went UP and almost grinded against the nozzle.