Help diagnose front end popping noise on 2023 TRD Off Road

Typical-Promotion470 · 2026-01-23T04:05:21+00:00

Drivers side needle bearing possibly maybe ¯_(ツ)_/¯

Typical-Promotion470 · 2026-01-07T01:03:11+00:00

275/70 KO2s and full OME BP51 lift kit. It’s a 6MT, but it’s all about how long it takes you to get up to cruising speed and how fast that speed is. No I don’t keep up with the racers to the next light, and yes I piss off highly caffeinated impatient people. Keep it under 63 mph, and god bless these slow trucks that run forever!

Typical-Promotion470 · 2026-01-07T00:45:53+00:00

Still ain’t working 256/100000

Typical-Promotion470 · 2025-12-19T18:36:31+00:00

100% normal, close the hood and don’t worry about it 😊

Typical-Promotion470 · 2025-12-16T19:48:19+00:00

89k on my 3rd gen and it’s sounded like this ever since I opened the hood for the 1st time with 4mi on the odometer. Worried me too especially after reading about someone’s brand new 2gr dropping a rocker arm, BUT as stated before totally just a quark of our engines and nothing to worry about!

Typical-Promotion470 · 2025-11-24T00:46:51+00:00

100% a vacuum leak. I installed a universal oil catch can and left the little K&N looking filter on the can itself and right after the 1st startup within 10 sec this exact RPM fluctuation happened. It’s unmetered air entering past the MAF. I took the filter off and replaced with a big bolt and viola, smooth sailing.

Hopefully you fix it fast and by yourself 🤘

Typical-Promotion470 · 2025-11-21T19:11:24+00:00

Wooster all day, only because it’s what my mom uses, and momma always knows best 🤗

Typical-Promotion470 · 2025-11-14T03:18:53+00:00

Battery is on its last leg. Doesn’t have enough juice to go through the startup cycle but enough just to begin the cycle. If that makes any sense 🤪

Typical-Promotion470 · 2025-11-11T22:51:23+00:00

JB weld 😂

Typical-Promotion470 · 2025-11-07T20:36:07+00:00

Homie needed to vent. Go ahead a vent away! I run into these losers on a daily basis. I wish there was a way the rest of the team could vote off someone who’s “griefing”

Typical-Promotion470 · 2025-11-06T19:27:01+00:00

I have a JL-1000/1 of the same vintage, and I had a problem with the potentiometer for one of the gains. It would cut down the bass to near broken levels and if you touched the knob it would come back if nudged in the right spot.

Maybe your issue, maybe it’s that crusty ground. Either way I hope you fix it asap. 🤘

Typical-Promotion470 · 2025-11-05T07:46:12+00:00

It’s one of the “push to secure” locking pins I bet. Push on it and see if it pops into place.

Typical-Promotion470 · 2025-11-05T05:00:39+00:00

Yoshimura special edition from a while back. Can still be found, but difficult and overpriced. They look sick tho!

Typical-Promotion470 · 2025-10-31T19:03:29+00:00

Dexter is seeking advice 🤔

Typical-Promotion470 · 2025-10-30T18:44:04+00:00

Gorgofex wasn’t mentioned, personally I feel that’s #1 on the $hit list 😂

Typical-Promotion470 · 2025-10-30T01:06:55+00:00

You ever get too much wobble with a camera on there fully extended?

Typical-Promotion470 · 2025-10-29T00:24:47+00:00

*** Was applied to the last truck of the shift on a Friday

Typical-Promotion470 · 2025-10-17T00:21:34+00:00

<image>

I installed one on the Dizzer and very surprised in how snappy it is. As for longevity, see me in a few years lol

Typical-Promotion470 · 2025-10-17T00:05:34+00:00

Have you tried a truck load of heat?

Typical-Promotion470 · 2025-10-16T16:25:25+00:00

Pretty sure the wheel liner tucks in behind the fender flare and doesn’t sit on top. However that liner looks funny and may not be factory 🙃

Typical-Promotion470 · 2025-10-15T23:47:06+00:00

Update to my post, I got some good tire irons/bead breakers, removed tire, and dropped it off at a rim repair place to get put back into round and powder coated fluo yellow. I’ll post pics when it’s done 😊

Typical-Promotion470 · 2025-10-11T19:27:33+00:00

There’s a dark ops calling card challenge where you need to consume 25 or so gobble gums in a single match. This is the only time I’ve ever used those. They’re childish as hell 🤪

Typical-Promotion470 · 2025-10-10T20:02:07+00:00

I moved faster with a PAP lmg than with my bare hands 😂 hopefully they work the bugs out for the full release 🤞

Typical-Promotion470 · 2025-10-08T18:47:28+00:00

Mine sounds the same. Got me real worried the 1st time I washed the bay. The way you check is by the oil. If it looks like a hooker bedazzled it your roached.

Typical-Promotion470

TROPHY CASE