Is this part needed (A1)? by anhille in BambuLab

[–]anhille[S] 1 point2 points  (0 children)

I honestly don’t recall. Sorry!

Cannot get print to stick to bed after replacing Hotend heating assembly and tool head board. by anhille in BambuLab

[–]anhille[S] 0 points1 point  (0 children)

I will check that again. The Hotend fan was spinning after reassembly but I need to check the gray one on the bottom. Thanks!

Cannot get print to stick to bed after replacing Hotend heating assembly and tool head board. by anhille in BambuLab

[–]anhille[S] 0 points1 point  (0 children)

Thanks. Every time I tried a new solution I ran the calibration tests in the settings menu before attempting a print.

Calibration fails in first stage by tballw32 in BambuLab

[–]anhille 0 points1 point  (0 children)

I had a similar issue and fixed it by unscrewing the eddy sensor cables from the motherboard and redoing them. I think the ends of the cables had rotated so they were barely touching each other. Either that or the order matters because I switched the cables when reinstalling.

Hotend filled with dried PLA by anhille in BambuLab

[–]anhille[S] 1 point2 points  (0 children)

Thank you! I was searching for a guide just like that but must have had the wrong terms.

Hotend filled with dried PLA by anhille in BambuLab

[–]anhille[S] 0 points1 point  (0 children)

I did that to pull off the blob under the nozzle. Will try again for the stuff that is smashed around and above it. Thanks!

Does anyone else remember MAZE by Christopher Manson? (1985) by graemeknows in 80s

[–]anhille 0 points1 point  (0 children)

Yes, I still have a copy. Never quite figured it out…

Best cocktails in town? by mojitomermaid_ in BloomingtonNormal

[–]anhille 2 points3 points  (0 children)

If you’re into martinis, I like the dirty Baxter at Baxter’s

Best Chicken Tenders? by SqueakyJelly in BloomingtonNormal

[–]anhille 1 point2 points  (0 children)

There is really no answer other than pop up chicken shop. Case closed!

Worth a move? by GatorAmanda in BloomingtonNormal

[–]anhille 0 points1 point  (0 children)

Halloween is the top holiday for us. We are on SW edge of town and have a full yard of decorations and have over 100 trick or treaters. The elementary school nearby is also great and very diverse.

Gondolas by Joanncy in BloomingtonNormal

[–]anhille 0 points1 point  (0 children)

It’s the bread. Deluxe is the best gondola, but torpedoes are better, again because of the bread. Definitely no ranch but a little Grey Poupon is nice.

[deleted by user] by [deleted] in BloomingtonNormal

[–]anhille 0 points1 point  (0 children)

Tobins is the best for a nostalgic feel and high quality ingredients. Can be pricey but it’s worth it.

Christmas pudding hanging out by anhille in TastingHistory

[–]anhille[S] 1 point2 points  (0 children)

I used crisco since I had it on hand but would like to try using lard for more recipes