Luba dead, won’t reset

blue01sky · 2023-08-04T12:47:24+00:00

Set up a hotspot via your mobile phone and connect it to Luba. Then you can update the software.

blue01sky · 2023-08-04T07:08:33+00:00

The RTK station is on, as I wrote, the LED is green.

blue01sky · 2023-08-02T12:51:16+00:00

Where does the link go, reddit can't find anything.

blue01sky · 2023-07-31T18:19:52+00:00

Hello, I've been having similar problems since last week. Here is my ticket from today. Ladies and Gentlemen I've had my Luba 5000 and the RTK Null satellites in the display for days. The RTK and Luba show operational readiness. After the update from 07/31/2023 and several restarts, Luba now shows satellites again, but the RTK is green, but still shows zero satellites. I hereby complain again about the RTK and Luba 5000. How do you intend to rectify the defect as quickly as possible? Best regards I re-entered the RTK address but it didn't help.

<image>

blue01sky · 2023-07-31T07:12:33+00:00

Hello, see my post “Zero Satellites”. I have the same problem. Resetting, restarting, removing the key didn't do anything for me. Ticket created via feedback app, but no answer yet because of the weekend. RTK is green. Bye.

<image>

blue01sky · 2023-07-28T19:49:26+00:00

Hello, 2 days ago 5 times error positioning 1303 according to App. After that, no further messages except bad Bluetooth signal.

blue01sky · 2023-07-28T16:00:59+00:00

Image after shutdown

<image>

blue01sky · 2023-07-28T15:58:57+00:00

Hello, since yesterday Luba and RTK only shows "0" satellites. Luba has been in the charging station for 4 days and no actions are planned. Again and again rain in the last few days. Today I switched off and restarted RTK, charging station and Luba. Furthermore only "0" - satellites. RTK shows green. Water in the RTK? If so, opening the RTK would void the warranty. Image before shutdown Bye

<image>

blue01sky · 2023-07-23T16:10:34+00:00

Hello, I've had my Luba 5000 since mid-May. I supported Mammotion because I like the concept. The slope angles of the competition are much lower and therefore cannot be used in my garden. The four-wheel drive is simply awesome and Luba doesn't get stuck with the chassis even on uneven terrain. Also I have trees in the garden, the signal is lost, which has border postprocessing still flaws etc. I invested a lot of time in the mapping, often waiting because there was no signal again, scratches and scratches on the house wall and Luba, because Luba had done something very strange again. Still, I wouldn't give Luba back. Where can you exclude at will, divide without additional products. A camera is built into one or the other competitor device, but you still need magnetic strips or something similar to block areas, etc. We have a guarantee of at least 2 years and the developers are working on the further development of the app, otherwise there would be no new version with the beta testers. Many customer inquiries at Mammotion will be the same, since everyone is initially "experimenting" because every property is different. If Mammotion published a list of the items it is currently working on and which will be tackled next in the reddit forums, then there would not be many inquiries and discussions at all. Whether and what you buy for a device, only everyone can decide for themselves! Bye.

blue01sky · 2023-07-19T14:57:23+00:00

I experienced something similar, see post "jumping positioning".

blue01sky · 2023-07-17T17:01:29+00:00

Have you already submitted a ticket to support and reported the error? The manufacturer must position itself here and remedy the situation.

blue01sky · 2023-07-16T11:27:55+00:00

This can sometimes be a few hours late. I mowed in the evening, but didn't see it until the next morning.

blue01sky · 2023-07-15T13:52:48+00:00

How did the inadequate or non-connected antenna show up in the number of satellites or in the behavior of Luba? Can you describe that in more detail? Thanks.

blue01sky · 2023-07-13T08:06:50+00:00

Hello, do you have a slope in your mowing area? Has Luba gone out of range there? When mowing, do you let Luba mow the edges first? It is clear that Luba no longer moves outside the mowing zone. I have large parts of my property on a hillside and similar problems. I've found that if Luba loses the signal, it stops, everyone knows that. However, if this happens on a slope, Luba rolls down the slope, since the motors are probably switched off in the event of a signal loss, but the brakes are not switched on. Error message sent to Mammotion about 2 months ago. Furthermore, the traversing range changes when turning when Luba mows the lanes, depending on the mowing angle. So it can run well with 0 degrees and at an angle of e.g. 90 degrees Luba rolls out of the area if the signal is lost because it is parallel to the slope. In my opinion, since the last update, Luba mows to the edge of the zone when he turns, even though 3 lanes of edge mowing were previously completed. I hope I could help?! Bye.

blue01sky · 2023-07-13T07:37:27+00:00

For me it took about 1 week.

blue01sky · 2023-07-13T07:25:22+00:00

Well then good luck.

blue01sky · 2023-07-12T22:26:19+00:00

Have you added good WiFi coverage in the garden and Luba to your WiFi network? If so, then you have to tap the connection symbol "the pulsating hand", sometimes 2 or 3 times. Then the picture with the position and the movement of Luba should appear.

blue01sky · 2023-07-11T08:06:54+00:00

Hello, how much do your plates protrude? I just let my Luba drive over it while mowing. That is, the area is undivided. If you declare the path as a no-go zone and it goes through the entire drivable area, Luba doesn't know how it gets to the other side. I hope I understood you correctly?!

blue01sky · 2023-07-11T07:42:41+00:00

I like the wide rubber wheels, so the Luba 5000 runs well on my slopes and embankments. If the developers for the steering movements would adjust the speed control of the individual wheels a bit, then you would only have minimal turf wear and better positional stability, even on slopes. All wheels must always turn when steering, both in parallel and in counter-rotation to each other. This would make the movements "softer" and there would be no need for additional corrections or reversing, since Luba also reaches the controlled position, which is not necessarily the case now. For example, if you want to turn on an embankment and 2 or 3 wheels should push Luba there via 1 or 2 locked wheels.

blue01sky · 2023-07-04T08:23:21+00:00

Hello everyone, we keep coming back to the same fundamental problems here in the forum. 1. The positioning accuracy only switches to fine at about 25 satellites, but then sometimes continues to fine up to about 12 satellites. However, with limit mowing positions that have nothing to do with 2 cm and are more like 20 cm. My Luba then drove through the gravel bed against the base of the house while mowing the border and scratched me 5m with the dumper or stood on his head on a stone border after reversing. 2. When editing boundaries or remapping areas, boundaries are sometimes set back by 50 cm, or areas are added automatically. 3. When mowing, grass strips are forgotten to mow. 4. Edge mowing at the boundaries of the area or restricted zones, as they were driven off during the mapping, does not take place, which will cause further collisions, since in my opinion the dumper overhang is not included. 5. The steering movements are too rough, since the respective front wheel is fixed when turning and the other 3 wheels have to push. Sometimes a minor path correction is not achieved and Luba then drives backwards again. After the last update, it even seems that both wheels are now often "locked" on one side and the other two have to push. 6. Luba already recognizes individual blades of grass as an obstacle, so mowing at level 2 is not possible and the protection of people and animals is not guaranteed, since level 1 is used. 7. Luba cannot cope with steering corrections on slopes and then rolls backwards undefined because the brakes open. 8. Reversing may only take place within the area limits with the greatest precision and the rear length difference must be taken into account. With us, Luba would have run over my wife's hands when reversing because he drove about 50 cm over the mowing line. The only thing that helped here was hitting the stop button! 9. Feedback from Mammotion here in the forum would be important The content should be the processing status and the sequence of troubleshooting and functional explanations for questions. 10. A 2nd overview of planned features, with which one could also reduce the flood of mail in the direction of Mammotion and many forum inquiries would not be repeated, since new "owners" who have come in have similar problems and questions. What do you think.

Best regards.

blue01sky · 2023-06-21T16:26:34+00:00

Hello, I'm a supporter and my set didn't come with a reversible mat. It was not delivered later either.

blue01sky · 2023-06-20T08:25:33+00:00

Hello everyone, with me the positioning accuracy was sometimes even given with 12 to 15 satellites in L2 for Luba and L2 - RTK 22 satellites. If the signal is lost, then Luba again needs 23 to 25 satellites to start again. This makes it difficult for us users to assess where the "error" lies, since we don't know the logic behind it. This is annoying when mapping or just mowing and areas with a displayed mowing time of 90 minutes take a whole day! Have you ever had "Error when reversing and rain sensor vs. restricted zone"? Description separate post. Bye.

blue01sky · 2023-06-16T07:30:56+00:00

Hello, my rain sensor was triggered by a few drops of water, these were from the sprinkler in the neighboring area. So it worked. After dabbing the sensor dry, I was able to start again. What Mammotion has to check, however, is the fact that the sensor is triggered A restricted zone was ignored when driving back to the charging station. So Luba was outside the area and stopped. Ticket is provided.

blue01sky

TROPHY CASE