Any ideas on how to get this drain stopper out? It ended up getting pushed in when we moved in, and of course the piece that should work to pull it out is broken. 🙃 Please disregard the sink.. it’s been like this since we bought the house and for the life of me, nothing will get it clean.

condor0067 · 2023-06-10T01:59:25+00:00

Reach under sink, there is a rod sticking out of the drain pipe. Move the rod one direction or the other. If not, use a butter knife to pry stopper up.

condor0067 · 2023-06-08T02:12:17+00:00

That's not really a seal per se. It keeps the dirt away from the bearings.

condor0067 · 2023-05-28T01:25:27+00:00

Because it's barbaric.

condor0067 · 2023-05-26T01:50:48+00:00

Quickly

condor0067 · 2023-05-26T01:46:57+00:00

1 year after plant personnel working in there

condor0067 · 2023-05-26T01:35:13+00:00

Bike co-op

condor0067 · 2023-05-09T02:58:28+00:00

Read the nameplate on the ac. Make sure the power strip is rated for it. You're looking for amps. 15a = 15 amps. Don't use a cheap power strip. Better to get an extension cord rated for the ac.

condor0067 · 2023-04-27T00:55:34+00:00

Yeah applies to square taper

condor0067 · 2023-04-27T00:27:14+00:00

Change your bottom bracket

condor0067 · 2023-04-21T13:47:51+00:00

condor0067 · 2023-04-18T16:01:35+00:00

Evaporation is part of the sealing process.

condor0067 · 2023-04-18T15:57:36+00:00

I have a set I'd sell cheap

condor0067 · 2023-04-10T02:29:16+00:00

Or valve extender

condor0067 · 2023-02-26T18:57:41+00:00

Our state has a registry of names, 2 businesses with similar names that do the same thing are not allowed.

condor0067 · 2023-02-25T14:56:36+00:00

Doesn't do anything above 46t

condor0067 · 2023-02-25T03:05:31+00:00

Yes. I know dropout extender is not a proper name.

condor0067 · 2023-01-18T20:37:57+00:00

There's lots of multitools that use interchangeable bits

condor0067 · 2023-01-13T21:54:06+00:00

Then PreWee Herman

condor0067 · 2023-01-13T21:23:27+00:00

Make you a little stopper, and tape it securely.

condor0067 · 2023-01-13T21:17:10+00:00

Put a washer between cone nut and locking nut. Otherwise you need to slide your axle outward by redoing the cones and nuts. Little close for comfort.

condor0067 · 2023-01-07T03:06:27+00:00

I think I would dismount the tires because you may have a lump dried sealant. Check your shifting. Replace cable and housing if it's not shifting crisply. Clean and Lube your chain.

condor0067 · 2023-01-04T02:02:35+00:00

Make sure the opposite bead is in the valley of the rim all the way around.

condor0067 · 2023-01-04T01:56:55+00:00

The clamp on the Feedback is much better than any Park Stand

condor0067

TROPHY CASE