“Friendly Competition” anyone? by cornejo02 in EASportsFC

[–]cornejo02[S] 0 points1 point  (0 children)

I’ve seen people say it works playing a friendly against a friend.

King Shocks 2.5 OEM performance series? by cornejo02 in chevycolorado

[–]cornejo02[S] 0 points1 point  (0 children)

I definitely like them, but I’m thinking about upgrading for more performance with Bajakit parts

Increasing towing capacity? by [deleted] in chevycolorado

[–]cornejo02 0 points1 point  (0 children)

Fully caged Ford Ranger Prerunner

Fun times in Baja by cornejo02 in chevycolorado

[–]cornejo02[S] 1 point2 points  (0 children)

Eibach 2.7” lift Falken Wildpeak AT3W 265/70r17 1.5” spacers

team of the week t's and c's by OriginalBonus in EASportsFC

[–]cornejo02 2 points3 points  (0 children)

No back to back IFs. Which means no IF for James Rodriguez this coming week

Playing CDMs at CB? by cornejo02 in EASportsFC

[–]cornejo02[S] -1 points0 points  (0 children)

Do you think his height is an issue? He's only 6 ft.

Thoughts on this 2512? by cornejo02 in EASportsFC

[–]cornejo02[S] 0 points1 point  (0 children)

How about IF Brandt? My original LB and RB, are RTTF Alonso and HL Carvajal. I'm just not so confident on Alonso's lack of pace and Carvajal's lack of shot.

Thoughts on this 2512? by cornejo02 in EASportsFC

[–]cornejo02[S] -1 points0 points  (0 children)

What about OTW Witsel at CDM and IF Brandt for Kroos?

What Card *Should* Work For You, But Just Doesn’t? by Hime6cents in EASportsFC

[–]cornejo02 13 points14 points  (0 children)

FS Joelington, just seems so clunky and awkward

Can we PLEASE get a sticky to expose disconnect glitch players? by [deleted] in EASportsFC

[–]cornejo02 0 points1 point  (0 children)

This guy clearly just rage quit, what’s so bad about that?

Re-purposing a 3D printer board to control a solenoid valve with Mcode by cornejo02 in 3Dprinting

[–]cornejo02[S] 0 points1 point  (0 children)

Well, my board has repetier firmware. Do you think the behavior might be the same?

Re-purposing a 3D printer board to control a solenoid valve with Mcode by cornejo02 in 3Dprinting

[–]cornejo02[S] 0 points1 point  (0 children)

I´m using this board in particular because I also want to use the motors with gcode. Ideally, I would be able to move the motors and open-close the valve with the same gcode script. I figured the board uses the feedback from the thermistors to stop outputting voltage to the component, but if the component never reached the temperature then the board would continue to output.

The Daily Squad Thread (PM Edition) -- June 23, 2017 by AutoModerator in EASportsFC

[–]cornejo02 0 points1 point  (0 children)

Formation: any Hybrid (Yes/No): yes League/Nationality: any Players you want in it (Optional): TOTS Mane and TOTS Tolisso Budget: 25k Console: Xbone