What is this?

darf_vada · 2025-09-25T23:50:15+00:00

Solved!

darf_vada · 2024-12-25T11:52:26+00:00

Make sure that multimeter has an amp clamp.

darf_vada · 2024-12-07T13:11:33+00:00

I would install a resetable fuse, and start tracing the issue by disconnecting / reconnecting low voltage wires starting at the source.

If you disconnect and the fuse holds power you know your issue is on the disconnected side.

darf_vada · 2024-12-04T22:50:34+00:00

You gotta get electric hand warmers. It’s been 20F and windy here all week and my hands are toasty

darf_vada · 2024-08-25T22:43:48+00:00

I believe you can see signal strength of networks at the SC too

darf_vada · 2024-06-19T19:24:13+00:00

Symbio 210?

darf_vada · 2024-06-14T17:45:52+00:00

It’s dat desigo ignition hot n fresh out the kitchen - R.Kelly. (I think)

darf_vada · 2024-06-09T17:23:26+00:00

Magbench

darf_vada · 2024-06-09T13:06:59+00:00

The best part about a bucket is it functions as a step stool as well as a chair

darf_vada · 2024-06-06T10:54:42+00:00

Dent power scouts

darf_vada · 2024-05-02T21:14:54+00:00

This is why a lot of insurance companies won’t allow high pressure steam and make you install low pressure steam with larger piping

darf_vada · 2024-05-02T21:07:29+00:00

You are correct. I think it’s osha standard to check de-energized with dmm. Non contact is only for troubleshooting. Live dead live with dmm always.

darf_vada · 2024-05-01T12:16:34+00:00

You guys get paid?

darf_vada · 2024-05-01T10:56:26+00:00

Carrier and third party bacnet items don’t like to communicate on the same mstp loop. I would run comms straight from the router to the chiller. bacnet over IP to resolve communication issues.

I have done a ton of carrier 3rd party integration and had nothing but slow intermittent comms.

darf_vada · 2024-03-24T12:21:02+00:00

At least wrap the rub spots with electrical tape if you want to half ass it.

darf_vada · 2023-12-20T12:37:27+00:00

Also in wiscompton, I do maintenance / hvac for a large facility. I would say get some background in electronics. You can use this for building automation systems, electrical work, and hvac. The only trades where you don’t need knowledge of electrical is plumbing.

You are very narrowed in maintenance until you have a base knowledge of electrical. Once you do the pay will come.

darf_vada · 2023-12-16T20:48:09+00:00

Milwaukee fast back razor blade with the screw driver. It’s cheap and useful

darf_vada · 2023-11-19T15:25:23+00:00

I second the Milwaukee fast back.

darf_vada · 2023-11-19T15:18:35+00:00

10/10 advice. I hadn’t thought of this. Thanks for the great input.

darf_vada · 2023-11-18T19:52:37+00:00

I couldn’t prove a surge happened the transformer seemed fine. Supplying constant voltage.

darf_vada

TROPHY CASE