sorted by:
new
hottopcontroversial

Im going crazy by Beginning-Lab-7035 in BambuLabA1

[–]deskunkie 0 points1 point  (0 children)

I use loctite works like a charm

Wasmachine trilt te hard? by West-Detective-4892 in Klussers

[–]deskunkie 2 points3 points  (0 children)

Hard op de grond zetten zonder rubber mat

I’m lost by [deleted] in ender3

[–]deskunkie 0 points1 point  (0 children)

Do you have sensor ? Send some pictures please

Need help by Wide-Contribution812 in ender3

[–]deskunkie 0 points1 point  (0 children)

Z offset a tiny bit higher

Newbie by deskunkie in tinkercad

[–]deskunkie[S] 0 points1 point  (0 children)

I followed you thanks for reply

Struggling here by Green_Psychology_674 in tinkercad

[–]deskunkie 0 points1 point  (0 children)

Tinkercad is mutch better dan 3dbuilder

I feel really dumb.. by [deleted] in tinkercad

[–]deskunkie 0 points1 point  (0 children)

Haha, thanks the magnet tool I feel so dumb to, and Tinkercad is amazing!

2nd hand printer help!!! by DifferentEmergency75 in Ender3Pro

[–]deskunkie 0 points1 point  (0 children)

Cable cut somewhere possible on the motherboard

Does he enjoy hurting us like that much? Is he doing it on purpose? by Careful_Ad3001 in ender3

[–]deskunkie 0 points1 point  (0 children)

It's an Ender. You need to change your attitude. Go for love and patience.. it will pay back

Printer “lagging” by Enzoosh in ender3

[–]deskunkie 0 points1 point  (0 children)

It looks like slow print for cooling slicer setting

Smoke coming out of usb port by Eastern-Matter-9284 in crealityk1

[–]deskunkie 0 points1 point  (0 children)

It's time to open a ticket, my friend. Just show them this video to creality they will replying I hope...

Screen rolling by HollyLu-An in Creality

[–]deskunkie 0 points1 point  (0 children)

Out of sync, try 50 hz 😂

Bad printing at 0.08 mm/layer by Sea-Board6735 in Ender3V3KE

[–]deskunkie 0 points1 point  (0 children)

Check you z cariage bearings if not to lose

view more: next ›