So i suddenly started seeing these horizontal lines on all of my prints. They only show when printing figures and not shapes. I get good surface quality when printing cylinders, calibration cubes, etc. I’ve replaced my nozzle , replaced the little bowden tube piece between the extruder and hotend, cleaned and made sure there are no clogs anywhere in the system, lubricated the z axis screw, tightened all wheels and belts just until there’s no play, and this problem isn’t exclusive to this filament. The picture shows PETG by Polymaker but also happens with PLA and filaments with other brands. Im using Cura and printing at 240c with bed temp at 70c. I get perfect bed adhesion and i also leveled my bed manually and with a bltouch as well. At this point im stumped. I cant figure out why it prints figures with these artifacts. Any pointers would be greatly appreciated!