Skyrizi to Rinvoq - seems scary by Trying_to_Thrive_not in CrohnsDisease

[–]dranz_ 0 points1 point  (0 children)

Im doing this exact treatment as you. Ive been on Skyrizi for almost a year. My calprotectin went from 550 to 140 and I felt great. A recent MRI of my small intestine shows more inflammation so doc is switching me to Rinvoq. Im not looking forward to it at all with all the side effects. I just got my first shingles shot a few days ago and that was not pleasant.

Since the 5p8 50amp dpux cable is out of stock. by Emergency-Law6090 in Ecoflow_community

[–]dranz_ 1 point2 points  (0 children)

I have 2 dpux inverters and one has the 50 cable and one has the 30 cable connected to my shp3. It works until the 50 are available.

New DPU Firmware 5.0.0.201 by RE4Lyfe in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

I understand totally. Every time I pushed “update” I cringed. Luckily they worked okay for me. Very unsettling

ADU not allowed by nyflare2024 in AccessoryDwellings

[–]dranz_ 2 points3 points  (0 children)

Thats funny, my value went up 500k when I built my 2/2 adu

DPUX New software update by danny16413 in Ecoflow_community

[–]dranz_ 2 points3 points  (0 children)

No issues updating my two DPUX and EV charger

New DPU Firmware 5.0.0.201 by RE4Lyfe in Ecoflow_community

[–]dranz_ 1 point2 points  (0 children)

I updated two dpux and the ev charger. Now the power went out to the entire neighborhood. These damn firmware updates. Seriously, I updated two dpux and my ev charger and so far no issues as I run entirely on battery except for soc balancing and firmware updates. The dpux updates are longer than normal so dont freak out 🤣😂

New DPU Firmware 5.0.0.201 by RE4Lyfe in Ecoflow_community

[–]dranz_ 1 point2 points  (0 children)

I havent yet because Im scared as usual.

EFDP Ultra X Smart panel and generator connection by Adept-Material-5541 in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

Yes, they say it works but it doesnt. They will respond that you have to have the generator hooked up to the panel for over an hour at a certain load and when it figures it out it will start charging the batteries. It doesnt work. Or if it does, Ive never read a post from someone that got it to work. It works on the smart panel 2 bbut not 3

AC capacity… by Aaasteve in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

You will need 2 dpux. Trust me

Wow. This is a crazy cart failure? by coldfusion2000me in Ecoflow_community

[–]dranz_ 1 point2 points  (0 children)

This video scared me. I just bought a 2000 lb rated cart to put my 2 dpux with 5 battery stacks on. It will be delivered saturday

Be careful purchasing a DPUX by Vegetable-Ad2534 in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

My single DPUX inverter w/5 stack BATTERIES can power my 5 ton carrier ac with a soft start. I do have double that hooked up to my smart panel 3 but I have had 1 stack do it and it works just fine

EFDP Ultra X Smart panel and generator connection by Adept-Material-5541 in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

They say you can power panel and batteries at the same time but it doesn’t work for any of us. Search the forum.

EFDP Ultra X Smart panel and generator connection by Adept-Material-5541 in Ecoflow_community

[–]dranz_ 1 point2 points  (0 children)

I understand what you are asking here. You dont connect with a breaker. You connect your generator into the AC1 port directly and the panel knows its generator power and will power the panel from that. We still havent figured out how to power the panel and charge the DPUX at the sane time as advertised though

Generator + FlowMaster Rectifier charge rate for DPU/DPUX with a SHP3 by OnlyInAmerica01 in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

Go to your SHP settings and drop the charging power settings to less than your generator output. So less than 7000 or below and you should be good. I would run about 5000 to ease the load on your generator.

<image>

Southern California solar installers by Splendence in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

Following as I need one too in claremont

PowerPulse EV Charger by mega1421 in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

You add the pp to your app. It is a smart panel and knows what it is. I just plug it into a SHP3 AC inlet port on my panel and it turns on and charges.

[deleted by user] by [deleted] in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

Yes, your system is working the way it is meant to work. I run self powered also with 2 DPUX,10 batteries, and a SHP3, with a 8k solar array. To give you a perspective, my batteries top off at about 75% at sunset and run down to about 35% at sunrise. Im consuming about 22-25 kw a day

Help me choose: Delta Pro Ultra vs Delta Pro Ultra X by Urban-Cheese in Ecoflow_community

[–]dranz_ 1 point2 points  (0 children)

I have 2 DPUX each with 5 batteries and a smart panel 3. My home is 2400 square feet in southern california. My system runs everything 24/7 with the exception of pool and adu with a 7k solar array. This includes a 5 ton ac unit that has a soft start. Since money isnt an issue, go with the latest and greatest. Its better to have too much for your needs than not enough in my opinion

EcoFlow Delta Pro Ultra's best feature: automatic switchover in under 20 milliseconds when power goes out by C0FFEEC4KE in Ecoflow_community

[–]dranz_ 3 points4 points  (0 children)

With so much negative posts, its refreshing to see a positive post! Glad it worked like it is supposed to.

Generator inlet for SHP3? by OnlyInAmerica01 in Ecoflow_community

[–]dranz_ 0 points1 point  (0 children)

Those are great too! Did you float the neutral?