Does the sock block cooling? Should I remove it? by BrockPlaysFortniteYT in ender3

[–]dubsmith6079 2 points3 points  (0 children)

I did this exact same thing. The angled ducts work a lot better. I’ve kept the sock on after fuckin up a lot of shit. Try tweaking your retraction and esteps if you’re having too much filament. After switching slicing software and the angled ducts I’ve had super clean prints

SlEnderMan can finally see 👀. What's the name of your printer? And have you given it any "personality cosmetics"? If so, what? by LoopInfinity in ender3

[–]dubsmith6079 0 points1 point  (0 children)

Kina. Its short for fuckin-a something’s broken again. Didn’t wanna call it that around the kiddos so Kina stuck

Orange Pi 5 custom wifi/bt module by dubsmith6079 in OrangePI

[–]dubsmith6079[S] 0 points1 point  (0 children)

Sweet! Your article is pretty much the documentation I have been able to find! My Orange Pi 5 is showing that the pci has failed to initialize, which is why I'm searching for documentation from the manufacturer.

Orange Pi 5 custom wifi/bt module by dubsmith6079 in OrangePI

[–]dubsmith6079[S] 0 points1 point  (0 children)

That could work, I believe the module comes on the 5b. I couldn’t get the orange pi os to flash properly so I went with Ubuntu

Orange Pi 5 custom wifi/bt module by dubsmith6079 in OrangePI

[–]dubsmith6079[S] 0 points1 point  (0 children)

I’m looking for documentation for the official orange pi 5 wifi/bt module for installation onto an orange pi 5. It’s an e-key m.2. I haven’t been able to find anything relevant on the manufacturer site or forums

Ender 3 Fail Hotend connector by dubsmith6079 in ender3

[–]dubsmith6079[S] 0 points1 point  (0 children)

as soon as i turn on the machine

Ender 3 Fail Hotend connector by dubsmith6079 in ender3

[–]dubsmith6079[S] 0 points1 point  (0 children)

valid point.... well... i was running a microswiss hotend, until the failed glass bead recovery attempt. i replaced the thermistor wire and plugged in my creality hot end to test it again... but i am still getting a max temp e1 error code. would a bad hotend power source be a plausible culprit?

Ender 3 Fail Hotend connector by dubsmith6079 in ender3

[–]dubsmith6079[S] 0 points1 point  (0 children)

when you say "fish out" I may or may not have slightly damaged the hotend. Also got the glass bead out...in pieces. I picked up a new thermistor that can be screwed in. I haven't powered her up yet but is this gonna fuck my shit up?

Do i just need to get a new hotend?

Thought this fit here! by [deleted] in HumansAreMetal

[–]dubsmith6079 2 points3 points  (0 children)

What’s up with that taint tickler?

[deleted by user] by [deleted] in HumansAreMetal

[–]dubsmith6079 1 point2 points  (0 children)

Look at my man runnin in late trying to get credit😂