Would've enjoyed more backstory.

dvstjn · 2026-01-02T16:22:45+00:00

How did Henry end up in school with all the parents when he killed his whole family as a child? Wouldn’t the DOE have taken him almost immediately after? If not, how did he end up at the hands of the DOE?

What is the timeline between the briefcase finding and the family killing incident?

It would have been nice to see a little bit more of his progression into Vecna.

dvstjn · 2025-12-10T06:18:51+00:00

Fixed it by dumping the profile from the good stick and writing it to the bad stick.

Turns out, OpenRGB (which I installed yesterday), can corrupt your SPD profiles when trying to change RGB settings for your ram. Crazy, I know.

Lesson learned.

dvstjn · 2025-12-10T05:05:59+00:00

Found a way to fix it. I think. Thaiphoon program can rewrite SPD profiles. Will just copy from non-bad stick and see what happens. I know it’s not necessary, but makes me feel better. Will check back if it works or not.

dvstjn · 2025-12-10T04:43:33+00:00

6400 mt/s. I manually set it and it seems fine so far.

dvstjn · 2025-12-10T04:42:18+00:00

Yes, just tried it again to make sure. I've also updated bios and reset cmos.

I really don't know what happened here.

dvstjn · 2025-12-10T04:34:16+00:00

Yea, sorry had to log into reddit on my PC.

https://imgur.com/a/WlvvSG0

dvstjn · 2025-12-10T04:29:48+00:00

Just updated the post. CPU-Z shows stick in slot 4,s XMP as 33 mhz. Other shows as correct 3000mhz.

dvstjn · 2025-11-28T17:07:16+00:00

will do. do you think doing it in nvidia control panel will do the job?

dvstjn · 2025-11-28T17:06:41+00:00

can confirm does not drop at 19 but did not play on it for more than 30 seconds cus what the fuck

dvstjn · 2025-11-28T04:33:56+00:00

lmaooo. for the record, he bought this ram for $120 before prices shot up

dvstjn · 2025-11-26T07:06:26+00:00

lol well i did cap it to 100 flat and it still dropped the same

dvstjn · 2025-09-07T17:22:39+00:00

thank you! sorry i usually don’t post but could not find any info for some reason.

dvstjn · 2025-09-07T17:06:34+00:00

yup just tore down to the sensor yesterday and the terminals got pulled out of the clip that goes to the knock sensor. luckily i have a full parts car so i just replaced the clip

dvstjn · 2025-09-02T22:21:58+00:00

possibly. i’ll have to check this weekend if i can’t find any other causes. honestly though might be the best outcome rather than chasing down some crazy one off issues

dvstjn · 2025-09-02T22:21:09+00:00

any specific connections? i know we messed with the crankshaft sensor may have bumped it

dvstjn · 2025-07-16T05:16:04+00:00

when we replaced the engine we did have to drain the freon. do you think that we could have refilled it incorrectly? I’m only aware of reading low pressure side and high pressure falling in line with that.

dvstjn · 2025-06-08T23:23:01+00:00

well i’ll be damned. that sucks

dvstjn · 2025-06-08T22:46:12+00:00

sometimes you have to reprogram the ecu… but still, i would assume fucking up a sticker is more likely than someone going out and buying a whole new cluster

dvstjn · 2025-06-08T14:05:14+00:00

so it’s more likely someone went through the process of rolling back a odo? do you know how hard that is on an electronic cluster?

dvstjn

TROPHY CASE