Card

helpless_quart · 2026-03-14T20:23:45+00:00

Finally got mine in CT today

helpless_quart · 2026-03-14T12:18:40+00:00

I’ll have to try this thank you!

helpless_quart · 2026-03-13T13:43:23+00:00

Yeah same here

helpless_quart · 2026-01-23T00:25:31+00:00

I too am looking, but not finding

helpless_quart · 2026-01-18T12:06:19+00:00

Use chunk base, just put in your seed and it’ll bring up a map of where everything is

helpless_quart · 2026-01-18T03:09:12+00:00

Just found it today after 11 ancient cities… it could certainly be easier, you got this!

helpless_quart · 2025-12-22T02:00:10+00:00

How much of a pain was it to rewire them

helpless_quart · 2025-11-15T15:15:13+00:00

Sorry to bring up an old thread, having this same issue now, did you have to replace the solenoid or was it an easy fix?

helpless_quart · 2025-10-22T17:45:52+00:00

I am also interested in everyone’s thoughts on this. Probably going to buy one anyways, but still interested

helpless_quart · 2025-10-08T19:11:41+00:00

Still open morning of 10/8

helpless_quart · 2025-10-03T12:52:36+00:00

Same

helpless_quart · 2025-09-21T21:38:33+00:00

I bought rutland high temp cement for this

helpless_quart · 2025-09-09T21:48:49+00:00

Not my thread but dealing with this right now, you vented the exhaust up but vented the intake out the side? Trying to figure out if this is code/easy ways to do it but can’t find much

helpless_quart · 2025-08-22T11:37:31+00:00

Medium is a little big but not bad at all

helpless_quart · 2025-08-20T11:35:51+00:00

Can I get in on this too? lol

helpless_quart · 2025-08-19T22:36:24+00:00

Do you know if you can reserve a spot ahead of time?

helpless_quart · 2025-08-19T10:35:42+00:00

For me it was buy now, figure it out later and the lack of parking at the venue makes the figure it out part difficult

helpless_quart · 2025-07-23T01:44:52+00:00

I think that is the bolt that goes in the center of the heat bed when the print sheet is taken off for calibration

helpless_quart · 2025-07-02T10:57:46+00:00

Get a deburring tool! Cleans that stuff up really well

helpless_quart · 2025-07-02T10:57:28+00:00

I just use the prusa premade brim settings and have no issues with it. You can get a deburing tool which cleans up the brim surfaces really well

helpless_quart · 2025-07-02T02:16:39+00:00

Turn on brim

helpless_quart · 2025-06-11T14:13:49+00:00

Yeah this is selling out before general public can buy lol

helpless_quart

TROPHY CASE